I cannot get to the "bypass Tray Type/size setting" screen when I want to change the bypass tray to plain. We have had this machine a number of years, we have always been able to change it, all of a sudden we can't
SOURCE: "P" is blinking. There is no paper jam. Paper is not feeding from the paper tray.
Hello sir; there is paper pick up roller dirty or worm, need to clean or replace.
SOURCE: Misfeed in tray one with no misfed paper. The
Pull out your paper tray (instructions below) and make sure there's not paper behind the tray blocking the motors from operating.
Else, worn rollers or broken lift motor.
First go to the service sim mode with the key combo # * C *
Type 22 - Start 9 - Start
If your tray 1 counter is above 100,000 your 3 rollers need to be changed. This is easily done by taking out the tray (you must tilt to the left and lift up at the end), unclipping and removing the paper guide, and unclipping and removing the 3 paper tires.
If your counter is under 100K try washing your rollers with soap and water, rubber cleaner and alcohol if you have it, but not Windex or 409. Your matched set of feed/sep tires should have some rough tread on them, if they are baby **** smooth its' replacement time.
If it pulls paper from a fresh stack and then stops pulling after a few sheets, the motor that continunally lifts the paper stack to meet the rollers has broken down, and can be replaced from the back of the machine.
SOURCE: We continually get a paper
Hi browngrand,
If the misfeed light does not go out, please look for any torn pieces of paper inside the machine leading from the bypass tray and remove them.
Please follow the steps below to correct the problem.
1.
2.
3.
4.
5.
6.
7.
Hope it helps.
Thank you for using FixYa.
73 views
Usually answered in minutes!
×