Brother printer that prints a black line down center

If you facing Brother Printer In Error State Windows 10 check this Answer.

Brother Printer In Error State Windows 10 is a failure normally displayed when the printer is jammed, low in paper or ink, the cover is open, or the printer is not connected properly, etc.

It is informed that customers usually face the Brother printer in the error state. There can be various circumstances liable for this problem. The obvious factors include outdated printer drivers, incorrect printer settings, certain technical difficulties within the print spooler service.

There are some method that fixes Brother Printer In Error State Windows 10 Easily check here:-

Method 1: Reset the Printer Settings.

Method 2: Ensure that the Brother Printer is Online.

Method 3: Set the Print Spooler Service as Automatic.

Method 4: Install Windows Pending Updates.

Method 5: Update the Printer Driver.

Full Blog- Brother Printer In Error State Windows 10

Try printing a test page to see if your ink levels are normal. Then instruct your printer to do a self cleaning, where it will clean the print heads.

Look in the manual and operate the cleaning cycle to clean the cartridge. If this fails, the cartridge may be getting low and require changing, but striping is usually because the cleaning cycle needs to be run. Good luck

Hello, Andrea.

Sounds like either your printer needs a new fuser assembly (If the teflon roller gets scratched or starts to disintegrate you will get lines or black marks on the page) or you need a replacement toner.

Hope this helps.

tthis is really old 25 years plus. replaced the drun cartridge which also contains the toner good luck canon sr tech

1,check the scannor unit,which is doccument feed in open the cover look the piece glass is clean.
2, replace drum cartridge.

Clean the inside of the printer with a soft rag, be gentle and get as much toner up as you can, also your toner carttridge may be empty or the crum may be bad, start with a fresh toner carttridge and clean the printer out where the cartridge sits.

open the top cover on the left hand side glass plateform with a narrow piece glass clean it with alcohol.

We were having a lot of print quality problems, similar to what you describe. We replaced the drum and it worked fine.

Seems like the drum needs changing. This is the most common cause for print problems in these printers. If using the high yield TN 6600 toner then you need to change the drum every 3-4 toners. If using the low yield TN 6300 toner then the drum will need replacing every 6-7 toners. Hope this helps