Message on phillips plasma TV reads "center input active"

use the remote control to reset

That model doesn't support 1080p
Change to 720p and you're done

The Akai is Samsung brand--have you when using that input that does not work gone into the menu and "selected" it and or highlighted it?

select the right input in your TV set, depending on what kind of device you want to use or connect to access the device.hope will help you.

According to " Consumer Affairs. com", the problems with seris of Phillips plasmas are innumberable. And they all start with the flashing red light, from 3 - 7 times. Baased on the information you gave, there is something wrong with the TV itself, not your perifrials. I would contact Phillips/ Magnavox to see if they will pay for an authorized sevice center visit, or even ship you a part to solve the problem.

Go to..
Menu / Setup / Source

Scroll down and Highlight Center Input, And select Off.

If it dont work first time round, Disconnect all Audio/Video leads from TV, and try again.

Hi jasonlambert,

You can use the remote control to center the picture on screen. Press to the right of the round pad around the OK button until your image is centered. (I had the same problem once)

-Jordan

Check your cables and TV input settings.  Can you get to the on screen menu?  Does anything appear on the screen when the tv is on?

S-video input is stuck in monochrome- when the small center box appears allowing you to change the input, the S-video box reads monochrome at the bottom. I cannot find a way to change this and have misplaced my user's manual. Help!
Thanks-
jg