The srceen filter is clean in the front but the clothes come out sopping wet
We had same problem. The pump was all clogged up with fabric debris, and a part of a metal bra liner. I removed the pump and cleaned it out. Now it seems to work fine, and went through a complete cycle. Ther pump was accessed from the front, and was not too hard to remove.
I too had this problem - there are two causes per the appliance tech that came out - one is the pump getting clogged - then you have to remove and clean it out. The other is a safety thing for small children - when it is too off balance the "brain" makes it go off so nothing can get smashed. Tell the difference: if you can hit start and it restarts mid load then a few minutes latter goes off again it is safety - if it does not restart it is pump
Hi
This issue usually occurs due to kinked drain pipe, clogged
drain filter or drain pump. First make sure that the drain is not clogged and
remove clogs if present. If no visible lint is present then remove the lower
front access panel to check the drain filter and drain pump for any clogs,
you'll need to clean the drain filter and drain pump completely. Hope this
helps... Please post back for any further assistance.
Daniel
472 views
Usually answered in minutes!
my washer will not drain or hardly spin it seems as if its stuck on like a pre rinse/spin cycle. how and where can i find the pump to drain the water or maybe some sort of filter. please help! the smell is killing me
I have a GE front loader washer that’s 1.5 years old that will not drain water once it reaches the rinse cycle. The problem has seemed to get progressively worse over the past month. Initially the washer kept going through the unbalanced load fault. In that it would not spin. Now it won’t drain water out nor will it spin. I called GE repair and their service charge is $80 just to come out and then they’ll tack on additional parts and labor. If anyone has advice, please help!!!
the washer will not drained
×