The screen works but gets cloudy like i increased the brightness all the way but i does it on its own and occaisionally goes yellow

To increase the brightness, either swipe up from the bottom to get the control panel, and increase the brightness there (slide the slider just below the 5 circles to the right) or go into Settings > Display and Brightness> Increase brightness using slider. You can also turn on the auto brightness from here if it is off, or turn it off if it is not working like you want it to.

If you mean the LCD display on the back of the camera you can adjust the brightness in the camera menu. Press the menu button, move to the yellow spanner with 2 dots top right, below this you'll see LCD brightness, highlight this and press set you'll then go to another screen showing a scale 1 to 7 use the left / right button to move the pointer closer to 7 to increase the screen brightness.

Press and hold the "Fn," or function, key on your EEE PC-1000's keyboard.

Press "F3" while holding "Fn" to lower the brightness on your monitor.

The brightness on your computer decreases each time "F3" is pressed.

Press "F4" while holding "Fn" to increase the brightness on your monitor.

Each time "F4" is pressed, the brightness increases.

Press "F8" while holding "Fn" to decrease the volume from your EEE PC's speakers.

Each time "F8" is pressed, the volume decreases.

Press "F9" while holding "Fn" to increase the volume from your EEE PC's speakers.

Each time "F9" is pressed, the volume increases.

Press the "Ins" key while holding "Fn" to take a screen shot, or make a copy of what is currently on the computer screen.

hope this helps

It goes black because it went into shutdown due to fault in the inverter circuits, check the 4 transistors in the inverter circuits for shorts, http://s807.photobucket.com/albums/yy352/budm/Dell%20E173FPb/

The headlights on my Tahoe are dim too. It's also a 1999. I replaced my bulbs with Silverstar's but it was still dim. I used Mequiar's Headlight kit to polish off the yellowing and oxidized headlight's and it really made them look good but they are still not bright. They look bright but the light hitting the road is still weak. It's because the inside of my headlights are a little bit cloudy still. The heat damage from the bulb made the insides cloudy and the light is still weak on the road at night. That's all I can do unless I replace the headlight assemblies. Much money and not super simple to do. I have very bright bulbs just cloudy housings that still don't allow the beam to fully shine through. I don't know if that is your issue but I hope this helps.

Decrease Brightness (fn+f7) The fn+f7 hotkey decreases the brightness of the notebook screen. The longer you hold down the fn+f7 hotkey, the more the screen dims. Decreasing screen brightness conserves power. » To increase screen brightness, press the fn+f8 hotkey.

Increase Brightness (fn+f8) The fn+f8 hotkey increases the brightness of the notebook screen. The longer you hold down the fn+f8 hotkey, the more the screen brightens. » To decrease screen brightness, press the fn+f7 hotkey.

Right click on the battery icon in the taskbar, go to Power Options or something similiar. Change the plan settings for the power plan you're currently in. Check the brightness ratio for both battery and plugged in mode. This problem might come if you or someone had tinkered with the settings.

the scroll button is already losing contact that why is not working properly..use a lighter fluid to the button then roll up and down untill the button is clean don't put to much fluid ok...

You have to send it back to company to fix this problem>

<Fn> + <→> Brightness up Increases the screen brightness.

<Fn> + <←> Brightness down Decreases the screen brightness

If tese dont work either your LCD lamp or board may be going bad.