SOURCE: Bosch Axxis front loader will not drain
check filter. check no foreign objects fouling pump impellor - bra wires are the favourite
SOURCE: Bosch WLF 2260
suspect you have filter blocked or a foreign object in pump. put drain hose as low as possible in a bowl and drain as much water as you can undo filter but be carefull, water will come out in considerable quantities. clean filter check nothing stuck in pump impellor
SOURCE: my Bosch classic 1200 express washing machine wont drain or spin
Possibly a blocked filter or pump.
Ths filter should be at the bottom right front of washer, sometimes behind a removeable cover at the bottom of washer.
To clean it, unscrew anti-clockwise, remove and clean.
SOURCE: Bosch Nexxt 100 series front load washer
You first of all need to check the pump filter.
This should be located at the botom front right of washer.
Look for a drop down flap or cover, once located, unscrew filter anti-clockwise to remove and clean.
The pump itself is directly behind the filter housing, check there is nothing stuck in the housing.
This should solve the prob.
Please leave feedback for my solution.
Thankyou.
Testimonial: "I submitted a question and got a very quick response. The response was useful and enabled me to make the repair myself. Thank-you!"
SOURCE: Bosch classixx 1000 washing machine - stops on spin
Washing machine stops at the spin cycle - light flashes. Have to drain water out manually. Happened last week and was then able to run an empty rinse cycle. Machine worked normally for another week. Same problem today but have had to drain water manually from the drum after trying an empty 90 wash and rinse cycle (both stopped on the Spin and flashed). Any ideas? Thanks. x
Turn program selector to "off". Turn
selector to Drain or Spin. Press the start / pause. Wait until program ends. Open door.
OR
Press "start / pause" until the start /
pause light flashes.
OR
First, unplug the machine and turn off the water supply. On the lower
right of the front panel is a 6" / 15mm cover. Near the bottom of this cover
is a small hole. Insert a piece of wire into this hole, and push in gently.
While pushing, turn the cover clockwise,
it will came off.
The door release is a narrow white plastic strip
hanging down on the right; Pull down on this strip while pushing in on the
door, the door lock will release.
Pl click if helped
Make sure dial is switched
to 'off'. Unplug your machine, then plug
it back in. Hold down the rinse and delay buttons with one hand. With the other
hand, switch the dial from off to cold or warm or whatever cycle you want. All the buttons flash a few times, then just
the start button flashes. If if doesn't work, do it again.
To get the clothes out if
you are having trouble, open door manually. Near the bottom of this cover is a small
hole. Insert a piece of wire into this hole, and push in gently. While pushing,
turn the cover clockwise, it will came off. The door release is a narrow white plastic
strip hanging down on the right; Pull down on this strip while pushing in on
the door, the door lock will release.
Click helped if helped.
248 views
Usually answered in minutes!
×