My Motorola H500's light never turns solid to be able to pair up with a new phone. It always blinks. Any suggestions?

Here are the steps to connect your Motorola H500 to your Nokia 2680 phone:
1. Switch off your H500 by pressing the main button for few seconds. 2. Put the H500 in discovery mode. To do this, press and HOLD the main button till it glows a solid blue light (no blinking). 3. Open bluetooth in nokia phone. Go to Menu, settings, Connectivity, Bluetooth. 4. Select "Add a new Device" and search for H500 5. Click on the name select pair. 6. it will ask for pairing code. Enter "0000"
You are done. Revert in case you have any problem

Hold the phone button down for about 4 seconds.. The light should blink 2 times and then stay on to add device to your phone once connected light will go out...Hold button down again light will blink 3 times and go off...........

go to the menu on your phone select manage connections turn on the bluetooth then you'll see search listen, etc. position on search don't press yet
get your ear piece ready: press the on button and hold it until you see a solid blue light (not blinking but solid) if it blinks try again until you get a solid blue light (it takes about 5-8 seconds) when that happens go to your phone and press search it will look for devices (it may find several) look for your earpiece model and select it
it will ask for a code or passkey, type 0000. Then it's going to ask if you want to bond or pair click yes and it will connect
check on the connection manager again and your bluetooth should be on and connected.
if it works for you, don't forget to rate me


thx

You need to put your H500 into "pairing mode" by pressing the call button until the light turns steady blue, instead of blinking. Your droid will then see it when you are in the Bluetooth Settings screen under Networks & Wireless. I just did this myself last night and it worked fine. Be forewarned, however, that you cannot voice-dial with your bluetooth - only answer calls. There are several forums out there that are bashing Motorola & Google for not having this basic functionality.

-Be sure the headset is fully charged.(plug it in till the light turns off.)
-Hold the talk button down for 4 seconds or until the blue light goes solid (not blinking.)

Now the device should be ready to pair with your Blackberry. It usually only stays in pairing mode for a short while (approximately 90seconds)

To pair the headset, first turn off the headset if it’s not already off, hold the multi-function button until the LED light turns solid blue (not blinking blue) with an audio indication, then use your phone to discover and pair with the headset using “0000” as the default pass code.

Turn the bluetooth off and go into the phone to search for devices, then turn the bluetooth on holding onto the on button until the blinking blue light turns solid for a couple of second then let go. The device should come up on the blackberry as Motorola H500, pair it and enter passcode 0000. Goodluck

This is the same headset I have.

I believe you have to hold the power button in until the light starts to blink, then tell your phone to look for the device. Don't forget to remove the device in your blackberry if you are still using it.

Here is the link to the instruction manual

http://www.motorola.com/mdirect/manuals/QG-H500_9494A56O.pdf

Don't forget to start with your headset off...then turn it on, but HOLD the on/off button down until the flashing blue light turns to solid blue light. This gets it into "sync" mode. The password is 0000 but it does not always work the first time. Don't give up! Try it again if it fails with the first try! Good luck!