What to use if i dont have jingle bells to make a jingle instrument

Unfortunately, it's a design or manufacturing problem with all of these. If it's new enough return it and get a different make of amp.

If the disc is "homemade", some players will NOT read the disc. If this is NOT the problem, it is unlikely anything internal would be a DIY repair.

yea im having the same issue.reason worked fine on my other comp.but as soon as i installed it on my laptop, i got this problem,it only plays the first instrument i load on my audio rack.if you toggle to the rear of the audio rack (press tab to view) the wires are not connected correctly.so i added a line mixer 6:2 and re routed the wires myself..and got it all working.

It sounds like the sensor is bad in the unit... If you have only had it a few weeks, exercise your warraaanty for replacement. Repairing the piezo sensor is NOT really a DIY project.

Try removing your tuning slide and while pointing the bell toward a light source ,look in the tuning slide end of the bell. You might have the rubber grommet from the end of the stand stuck in there. If so carefully use something smaller than the diameter of the tubing to push it out towards the bell opening.. A piece of wooden dowel should work.

thats not what im talking about theres people that are geting free vips and i dont get how to get one!

there is now homemade solution for pa800 with 128mb ram, i have 128mb in my pa800. but u cant just put new ram, its kinda complicated.

Have a look at www.stewmac.com. There is a good edscription of what you want to know at www.fretnotguitarrepair.com.

you plug it in to any channel you want just lick a mic.
there you go DFD