Making the ebox a stand alone system to work with any tv

Step 1:
Follow the steps provided in the below link and check if it resolves the issue.
http://windows.microsoft.com/en-us/windows7/troubleshoot-problems-installing-service-pack
Step 2:
if step 1 fails, I would suggest you to place the computer in clean boot, then try to install stand alone SP1 package.
To place the computer in clean boot, follow the below article.
http://support.microsoft.com/kb/929135
To install SP1 stand alone package, visit the below link.
http://support.microsoft.com/kb/976932
You can also refer:
http://support.microsoft.com/kb/2505743

I cant find any info on your computer, the company stopped trading in 2008, but you can use some software to check everything about your computer.
I use PC Wizard by CPUID, its free and will tell you everything.
Find it here http://www.cpuid.com/softwares/pc-wizard.html

You should contact Cuisinart's Customer Service as they really stand behind their products and should be able to help you with getting a machine that works correctly.

I've been very impressed with how fast they work to resolve issues with faulty units and they are very prompt in getting back to you with an answer. Give them a call at 1-800-726-0190

Here's a link to their website for contact info, just select United States or International and give them a call or fill out the online web form. It's a good idea to have your model and serial
number available when you call.

Rather than go into what you could do, since your coffee maker is about 1 year old, I think you'll discover that it's still covered under their warranty.

Hope you find this info helpful and best regards!
http://www.cuisinart.com/support/contact.html

First, stop to realize that some monitors are powered through the cable that comes from the computer stand alone unit. Some get power and have a normal electrical receptacle in the rear of the monitor. Some monitors have a little hole for the installation of a small plug from a step down transformer. Kind of like the one use in cell phones. If you have any lights on the monitor....then it isn't the power. If you do, then replace the cable from the stand alone to the monitor. Or, if you have another monitor, try it with your stand alone. But, most trying to help you are RIGHT. Details, you might wish to give more detail to get an accurate effort from this support page. Good luck.

The AU failed to transmit 100 consecutive Beacons, causing the unit to auto reset.Usually this happens when the media is busy (RF signal higher than the “Carrier Sense” value is detected by the receiver.