I need a repair manual for a Kango 900 demolition hammer, might anyone have a copy . the wheel above the piston has the offset bolt broken off. motor runs perfect6 but of course the chiesel bit does not move! wayne finner [email protected] or on this bullitin board
I also have a kango hammer. The motor is running, but the chisel has got no force behind it, it is just vibrating slightly. It sounds like it might be the same problem. Is this issue common?
I also have a kango hammer. The motor is running, but the chisel has got no force behind it, it is just vibrating slightly. It sounds like it might be the same problem. Is this issue common?
Hi mine was similar put general purpose high heat grease on tool and it worked to a degreeHi mine was similar put general purpose high heat grease on tool and it worked to a degree
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
kango 950 was the hammer drill version. Usually when they stopped hammering they were due for a rebuild. These units have a aluminum piston that rides in a steel tube striker. When the 2 rubber piston rings wear out you will get the described problem. The Kango's use a special tan grease so you cannot just yank it apart and replace the 2 rings with o-rings and grease. I had to rebuild 15 900 and 950's because the previous mechanic used the wrong grease. https://project21designs.com/kango-950-parts
The link sells grease & rings.
The shaft from the motor to the drive gear is likely not working the action of the hammer. There is a gear which spins the gears to achieve the hammer action, suspect the gear is either stripped, broken or both.
i have 900 kango jack hammer motor work but don't jack in sacramento any repair dose work on the jack hammer can you give info who work in sac thanks jim
Milwaukee now owns Kango, unfortunately I believe the 950sv is the old style. Parts are no longer avail. I have about 20 of the breakers. It is really too bad, they were great machines.
I also have a kango hammer. The motor is running, but the chisel has got no force behind it, it is just vibrating slightly. It sounds like it might be the same problem. Is this issue common?
Hi mine was similar put general purpose high heat grease on tool and it worked to a degree
Hi did you get manual if so can you forward it on
Add a CommentCheers
×