How to change broken door handle on Wd 8074FHB

check the dampers

Check this link: Door lock

This is not an identical one but is another LG that has the same latch setup. Hope these pics help.

My back hatch would not open but it appears the lock was sticking and the return spring to the handle is broken. We used the key to unlock the back door and then door opened. Then husband sprayed WD 40 in all the lock holes. Now once we open the door we have to push the handle back down as return spring is still missing but the door opens :) . My van is a 2002 Ford Windstar.

inside handle is broken you need to replace the handle

"de" means door is open you have to close the door titly then press the start bottom or check door switch if its out of order or not with digital multi meter.

the door lock mechanism has a broken spring internally .door lock has to be replaced.

Door assembly needs replacing, can open door using old credit card/drivers licence, sliding between cabinet and door(toward centre area of handle-behind it), pushing the door lock in left hand direction, you can remove the items from machine.

the spring in the door handle assembly is broken,the spring is replaceable seperatly.

Common problem on 2001 Ford Explores. The reason why your door handle doesn't unlock the door(can't be unlocked by remote either)is due to a broken spring located on the backside of the door handel INSIDE the door. True that your one(or two) of your small exterior springs on your door handle are broken(will cause your handle to flap) but this IS NOT YOUR PROBLEM. The door locks will work if there is a bit of tension holding the handle bracket up. I know it's hard to explain without pics. but here's the ONLY WAY TO FIX THIS. It's not that hard.......... Remove the door panel, only a few screws and a few more holding trim around exit handle then, pull out "snap in" clips on bottom. With a flashlight you'll see back side of door handle. To get to that area you'll have to remove one bolt holding a window frame. Do that(with window in up position) then slide down rail, out of your way. Now, get back to handle. With your light aimed at the backside of handle left slowly the door handle as normal, and you'll realize(while looking at the mechanism) that tension(pulling down of bracket) needs to occur in order for locks(manual and remote)to work properly. Trust me.....you'll figure it out. Once you do, get a spring(pen spring, 30 cent hardware store spring, any small spring!) and hook one end to bracket and the other end to ANYTHING(OUT OF THE WAY) below the door handle thus, causing SLIGHT tension. Try your locks...THEY WILL WORK! YEAH! Replace that one window frame bolt(try your window...just the make sure), replace door panel and your done. TOTAL COST: 30 cents or FREE(if you have a small spring) Ford dealers will charge $150 to $285! Yikes!