Phaser 860. I replaced maintance kit and it came up with sevice a

There should be a door on the right side of the printer. Replace the maintenance kit and clean the waste ink tray.

I’m happy to help further over the phone at https://www.6ya.com/expert/eric_7148ad2a373711a3

. they replace a certain number of pages printed by the manufacturer data
maintenance kits are easily user installable and come with a fuser assembly, transfer roller, and pickup, or feed/separation rollers.

Most likely if it is not moving the paper out of the tray the rollers will need replaced. You can try cleaning them a few times with soapy cleaner, and alcohol.
Honestly, you could probably pick an entire 860 up on E-bay for cheap for some of the parts, But feed rollers I would get new.
Not sure of a non Xerox source for those. You can try Precision rollers, The Parts Drop, and Xerox phone number to order those parts would be 1-800-835-6100, follow prompts to parts and you can just inquire. They will give you prices and look up what you need with no commitment.

check your maintenance kit. You probably need a new one. It sounds like the maintenance roller. Maybe the tray the roller fits in is defective.

Hi,

You could try the colour test procedure and just melt it out but that will waste a lot of link in all of the sections

Niall

Hi,

The user guide is available here http://www.support.xerox.com/go/results.asp?Xtype=docs&prodID=8560&Xlang=en_US&Xcntry=USA&prodName=Phaser%208560

Also, I think there are two wiper blades on the 8560, one is on the maintance kit and the other is supposed to be removed, that was the old 860 that could remove theirs. Perhaps cleaning it will be fine. just open the top of the machine and its right there, give it a wipe and it should be fine. The other wiper blade on the maintanance kit and here is a link below to show you how to clean it!

http://www.support.xerox.com/SRVS/CGI-BIN/WEBCGI.EXE/,/?St=355,E=0000000001343253407,K=1300,Sxi=12,Case=obj(902)

You can use this site to troubleshoot any problems with Xerox printers.

Niallbt

MaverickSolutions.biz gets all of our Phaser parts from DocJams.com. They're real experts in Phaser printers, reasonably-priced, and provide terrific support. Tell 'em we referred you.

If you are able to do the repair yourself, then remove a lamp from the preheater assembly and look at the voltage and wattage on the bulb itself...on some there is also a lamp part number.

you can also order a repair kit from e-bay. The same lamps are used in the Phasers 840, 850, 860 & 8200

Here are 2 links that have what you need (if the internal voltages for the printer are the same in europe as in usa):

http://cgi.ebay.com/Xerox-Phaser-840-850-860-8200-Drum-Heater-Repair-Kit_W0QQitemZ230320054253QQcmdZViewItem?hash=item230320054253

http://cgi.ebay.com/XEROX-PHASER-860-PREHEATER-ASSEMBLY-650-4228-00_W0QQitemZ350139954330QQcmdZViewItemQQptZCOMP_Printers?_trksid=p3286.m20.l1116

An 860 has no fuser. That sounds more like either a maintenance kit or transfix roller needs replaced.

Sounds like printhead needs replacement.
Moving these printers without cool down is known to destroy printheads and of course wax goes everywhere and then everything else fails.Think about replacement