Cold water won't stop

Parts here

Inglis Washer Knobs ' Replacement Parts & Accessories ...

www.partselect.ca > Inglis-Washer-Knobs

Control knob lets you control cycle settings. Remove the knob by pulling it straight off its post. Fixes these symptoms. No Symptoms for this part. Missing: 100 ‎lA48500

Inglis Washer Parts ' Inglis Washer Repair Parts - PartSelect.ca

www.partselect.ca > Inglis-Washer-Parts

The pin on the lid pushes on the lever of the lid switch to tell the machine that the lid is closed. This part includes the grounding wire. Fixes these symptoms Missing: lA48500 ‎control

Inglis Washing Machine Knob, Dial & Button Replacement ...

www.repairclinic.com > Shop-For-Parts > Inglis-Washi...

Start doing it yourself with the confidence that comes with 100+ years of experience. We've got millions of parts, hundreds of brands, and thousands of step-by-step ... Missing: Royal ‎lA48500

Troubleshooting - Inglis Home Appliances

inglis.ca > Customer Care

-; Turn the Cycle Control knob to the right slightly and pull to start. Are the water inlet valve screens clogged? Are both the hot and cold water faucets turned on? Is ...

Washer Manual and knob

https://www.manualslib.com/manual/77205/Inglis-Washer.html?page=10#manual

..

Please turn water off. This is not a repair you won';t undertake
https://www.partselect.com/Repair/Washer/Not-Stop-Filling-Water

Sounds like a bad water valve

This is an indication that the solenoid on the cold water valve is bad. Or the cold water valve is plugged. If you can get to the valves, use a meter to check the solenoid OR the power to the solenoid. That will tell you if it is bad. If you dont have a meter, switch the wires from one solenoid to the other and see if it fills

You may have 2 defective parts.
First,make sure the hot and cold water hoses are connected correctly and both turned on.
If the water fill problem is the same,the water temp switch is bad.
The not filling after the wash cycle could be a bad lid switch.
Set the machine for SPIN and turn it on.
If it does not spin,replace the lid switch.

Hi,

This is a common question we face daily. Certain washing machines allow hot water to enter only during certain cycles. Others allow hot and cold to enter intermittently. Consult your owner's manual to be absolutely sure about this. If you're sure the machine isn't working the way it used to--or should--try these tests:
Is the hot water turned on? If not, turn it on.
Is the washer getting cold water but no hot water? If so, check to see if the control panel
settings are correct.
Thanks for writing to Fixya.com and I am Aparajita. I will be assisting you today.

water control valve

remove fill hoses and inspected for debris or cloggs ,,,,

You will need to get behind the washer, turn the water off, disconnect the hose from the washer, look for a screen inside the water valve, hopefully there is one that you can clean if necessary. I always put the hose over in the washer and turn the water on to check the flow.

If the screens on both hot and cold are clear, water flow is good on both hot and cold, connect the water back to the washer. If the flow is still slow then the problem is inside the valve. The valve will have to be replaced.

The most likely cause for water fill temperature problems is the solenoid has burned out, usually cold first, it gets used more. Not a repairable item , easy to replace