Yesterday the DS603 starting beeping and wouldn't stop. The fault code was on rinse.....We unplugged the machine and then tried it again, same thing. We then left it unplugged overnight. This morning I tried it again and it went through the wash cycle just fine...ran for well over 45 minutes then started beeping again, it appeared to be in the dry cycle as the dishes were almost completely dry. I tried it again, same thing ran for about 40 minutes and then started beeping again. Now it's unplugged again and would love to know how to stop the beeping. any help would be appreciated. Thank you
Stop the unit and check to see if it's heating when it's beeping at you. eg is it warm water inside at the time? if not you may have a faulty element.
SOURCE: Fisher Paykel dishwasher drawer won't stop.
Let's go to diagnostic test mode to see if you can retrieve the the actuator hence the tube out.
1- Press Lock button and start/pause key until the display showing up.
2- Press Power to show HO.
3- Press start button to advance the display until you see P2 for draining, if you pass, keep doing it to get it back in a loop.
4- When at P2, press lock to turn on, press a again to turn off.
5- Listen to the sound of the pump. If you hear nothing that means the pump is dead or stuck.
6- The Motor has 2 directions: one for, Rinse and one for Drain. When you done with the diagnostic, press the power button to get out of the mode.
7- If this is the case, unplug the power then remove the rack, the bottom stanless steel plate with holes then take out the rotor to clean up. It is a good design the stator is outside of the tube, so you don't have to worry too much about the complication.
8- Make a note of all the positions so you can put them back the same as they were. Good luck
2,017 views
Usually answered in minutes!
×