USER MANUAL PDT6846 - Symbol PDT 6846 Wireless Portable Terminal

The manual is here.

https://cybarcode.com/sites/cy/files/manuals/symbol/pdt-6846_user_manual.pdf

That model is discontinued and is upgraded with 9000 Series

https://www.barcodesinc.com/symbol/pdt6846.htm


//

Looks like it needs professional service

https://www.google.com/search?q=Symbol+PDT6846+scanner+not+communicating

..

Warm Boot:

- Press the "PWR" button to turn the unit off.

- Press the "4" and "5" keys at the same time.

- While still pressing the "4" and "5" keys press and release the "PWR' button again.

- Release the "4" and "5" button.

- The PDT6846 should perform a warm reboot.

Cold Boot:

- Press the "PWR" button to turn the unit off.

- Press the "B", "D" and "A" keys at the same time.

- While still pressing the "B", "D" and "A" keys press and release the "PWR' button again.

- Release the "B", "D" and "A" button.

- The PDT6846 should perform a cold boot.

Probably not -- looks like corrupt firmware -- it'll have to go to a Symbol/Motorola Dealer for repair.

You can't, If you do somehow take it of like sawing it off it will leave a big hole in the bottom
Regards 

The PDT6846 is the wireless version of the PDT6800 Series terminals. There is a manual that covers the whole series and this link will take you to it: http://support.symbol.com/support/search.do?cmd=displayKC&docType=kc&externalId=3264502apdf&sliceId=&dialogID=114442201&stateId=1%200%20114440090

you can get it from www.wavelink.com they are quite good and still offer the files for the older terminals. however, you may need to get a license from them in order to use it on the pdt.

If you have loaded the radio drivers, exit to dos then type in CFG11 this will take you to the main configuration menu. From there press enter on the first option and voila. There you will be able to find the mac address.

The host ip setup is application dependant. You'll need to check with the vendor that supplied your PDT6846 5250 emulator.