Red light Permanent red line down right side of tv

the t-con board is under a small shield by the red on light at the base of tv

Nothing you can do about that...get used to it or change the TV.
It's a defect in the panel that can't be reliably fixed.

hello it sound like the convergance ic may be the problem these chips sit behind the tuner board connected to a metal frame called a heat sink they are soldered in. also you will have to check the resistor in front of the chips also check the 2 capacitors at either end it would be best to get a quote from and engineer good luck

regards
shaun

hi

I think your TV have a trouble inside lcd panel
the controller board contains driver IC. Deffective driver IC can cause of line display.



Three reasons why one vertical line accross screen can happen in LCD;

1.The missing signal from the controller IC to
LCD driver.
2. LCD driver IC itself defective
3. Dry contact in the tape carrier package.

Use masking or electrical tape to mark it where the line was located. press it if the line back to normal but when release your hand came back i think it was intermittent. Open the LCD panel


Use robber

Place the rubber on the top of TCP

Gently close back the top casing


Good luck...

Hello

black strip down the right side its about 2 inches wide there are also red and green flashing lights that is defective shorted capacitor at power inverter board section that was 300uf 200volts.

Angel
Thanks...

Hi friend, this is a problem of jungle IC on D board..u want a technician to repair it thank u,,,

Replace the timer control board

The panel is almost certainly bad. The only fix for this is to replace the whole panel which would cost more than the whole TV.

unfortuatly yes its permanent ts caled a burn mark

If your looking to service this set yourself you need to open the back cover and look down on the main pcboard with a flash light if you see any liquid damage it's more then likely your CRT's are leaking coolent fluid on to the main PC board, Common problem with most CRT projection TV's manufatured today, main board needs to be cleaned and the CRT's need to be sealed,