Question about Dryers
Check your vent and the vent hose. At least once our dryer wouldn't dry anything when the cover flap on the vent was dislodged and couldn't swivel open. Also check if the dryer is getting warm. If the thermostat isn't working (any dryer) or the burner has failed, you could see this problem.
I hope this helps.
Posted on Apr 26, 2013
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
Have you cleaned the exhaust ducting? The duct that runs from inside to outside. Try that first. Sounds like your exhaust line is blocked. Also with the filter out get a flash light and look down the venting if alot of lint vaccum out. NOTE: Unplug the unit, wheather gas or electric.....and if it is a gas shut off the gas to the dryer before moving just in case something gets loose while moving. Hope this helps.
Posted on Nov 11, 2007
sounds like the timer is not completing the cycle in this mode will the dryer shut off if you manuelly advance timer in that mode
Posted on Nov 01, 2008
is it getting hot ? if not then its either the heating elements or thermostat. both available on espares. Most likely to be thermostats. If its heating then give the condensor a good clean. hope this helps.
Posted on Nov 06, 2008
SOURCE: MCG8000AWW takes too long to dry
The font panel must be removed. This may be done by removing the control console (open upper cabinet doors to find screws behind the console). The screws along the top of the lower front panel are easily accessible. Disconnect the two interlock switches, remove the grounding clip attached to the bulkhead & lift the panel off the two lower clips. Inside the panel is a housing that leads to the exhaust blower. It will be packed with lint that may be hardened like papier mache. Just clean out the mess & reverse the process to replace the parts.
Posted on May 30, 2009
Check the following to address this issue--
Note: Normal drying time for a dryer is about 45 minutes (some may take up to an hour).
Make sure the dryer vent hose, as well as the rest of the vent duct, is not clogged.
Unless regular maintenance is performed, chances are there is a lot of lint accumulated inside the dryer. This might affect the drying time and could be a fire hazard. Make sure to have your dryer cleaned regularly. Because this might involve taking most of the dryer apart, it is recommended to have a qualified appliance repairman perform this task.
There are a couple of cycling thermostats inside the dryer. If one of them breaks down, it might affect the dryer's performance. Replace the defective thermostat.
3. Heating element
A heating element might only be partially burned out, in which case it would still work but will take longer time to dry the clothes. Replace the element if found defective.
Posted on Jun 03, 2009
Tips for a great answer:
Nov 14, 2012 | Maytag Atlantis MDE7400AY Electric Dryer
Jul 13, 2011 | Maytag Dryers
Jun 29, 2011 | Maytag Atlantis MDE7400AY Electric Dryer
Sep 11, 2010 | Maytag Atlantis MDE7400AY Electric Dryer
Mar 14, 2010 | Maytag Dryers
Sep 19, 2009 | Maytag Atlantis MDE7400AY Electric Dryer
Mar 16, 2017 | Maytag Dryers
Mar 13, 2009 | Maytag Atlantis MDG7400AW Gas Dryer
Jan 19, 2009 | Maytag Atlantis MDG7400AW Gas Dryer
48 people viewed this question
Usually answered in minutes!