Hi, i have a dynex 19" tv. i have been having trouble with a blue tint ever since i accidentally used autocolor in the factory menu. i have read that it can be fixed by going to other settings and using eeprom init, but i have no "other settings"!
SOURCE: dynex 19" tv
Go into the setup screen on the TV and set the channel option to CABLE (it is probably set to AIR right now or something).
The website should also have a manual for how to program the remote.
SOURCE: Dynex 19Inch Vga no signal
You may need to set up the video card to see the TV so you can display the computer on it.Somewhere in the setting for your video card should be settings for that.
SOURCE: We have a Dynex 19
After cussing at the thing for a while to get its attention,
I thought the problem over and fixed it as follows:
I went into the setup menu and selected the "reset default option. The set went to blue screen. The next step was to rescan the channels. Then in the time setup menu I turned off the automatic time update. So far have not had any more problems.
SOURCE: 19'' Dynex TV does not come up as a Computer Monitor.
Follow these steps on the remote :
Press Input,
scroll down and select VGA.
SOURCE: I bouth the dynex 32" but six months into use I
Either a lose LVDS cable going to the t-con board or a bad t-con board.If it's still under warranty I would take it back for service.
108 views
Usually answered in minutes!
×