I am trying to login as admin, to be able to change the default password and secure the signal, but the default username does not let me log in. I'm using 192.168.0.1, login-admin, password-(blank). How can I login as admin? Thank you
I was ready to give it up and pitch the thing, but I found this on another board and it worked:
login - admin
password - password (not blank)
This worked for me:
1.) Login as 'User' with blank password.
2.) Run setup wizard.
3.) It should bring up a new window which requires logging in again.
4.) Now put 'Admin' and blank password.
5.) Configure the wizard which will also change the Admin password.
Hope this helped ;)
Hi guys:
This link helped a lot:
http://borgetech.blogspot.com/2007/09/d-link-di-524-revision-b4-status-light.html
Only thing I changed was the IP address. I used 192.168.0.2 instead of 192.168.123.253.
Hope this helps.
Try a master reset, holding the reset button for 20 to 30 seconds. It will bring the router to the factory status.
I have smae problem with my motorola 2210.i update with new firmware after it its change the getway ip from 192.168.1.254 to 192.168.0.1 and when i logon its asked me password i try evry thing but its not working.ple help me.
Hey guys,
This helped me solved the problem. Only thing I changed based on the instructions given was to change the IP address to 192.168.0.2. But basically followed it step-by-step.
Hope this helps.
Try connecting directly to the router with a cable as if there is a problem with the wireless connection then you won't be able to connect. If you are already connected directly then reset the unit to it's factory defaults: Locate the Reset button on the back of the DI-624 (through a small hole next to the power cable). Use a paper clip to press the Reset button Hold for about 10 seconds and then release. After the DI-624 reboots (this may take a few minutes) it will be reset to the factory Default settings. Now try to login again directly via a cable.
7,548 views
Usually answered in minutes!
I have the same problem with my DI-624. With just a connection between my desktop and the router, I type in http://192.168.0.1 in my web browser and it takes me to a login window for the router. I type in "admin" and leave the password field blank and hit "ok." But then it just refreshes the login screen. It does that twice before failing with a "not authorized" on my browser. What is going on?? How can I login to this router? If I type in "user", it lets me right in, but I can't run the wizard since it says I'm not the admin. Please help! :-)
I am having the same problem with my DI-624. I cannot use "admin" to log in (with blank password). I held the reset button for 20 seconds hoping it'd reset it back to factory settings but that didn't help either.
Any other suggestions?
user name and pass is not correct why
When i type the link http://192.168.0.1/) into my browser i am prompt
with a box asking for a username and password. I was told to use
'admin' as the username and leave the password field blank, so i did.
The box just re-appears asking for the username asnd password again.
i've tried all sorts of ways and it will not work... am i doing
anything wrong? i just want to access my router and the page just will
not load!!! Plz help!!!
same problem as everyone else. never had this issue before.
×