Camcorder recording problem

hi, i dont think so usely it as to be made by the camera,normally when you finish recording
you press pause and then stop and let it go for few minutes and the camera should finilize
the disk by chapter,then eject.

hope that will help
regards Alan

I've got the same problem, also with a brand-new Canon Legria FS 20. As Canon told me, I took it to a Canon office to be repaired. It was repaired. I tried filming and it worked. Then I tried to view this film and I got the same error message again: cannot access internal memory. I also can't film anymore now. I'll call Canon now and ask them what to do. Repairing didn't help, I want a new cam, but I'm not sure the FS 20 is a good choice. There seems to be a problem with it.

It simply means that you are going to enjoy all warranties facilities only in national boundaries of your purchase. Even if Lenovo is an international company, it won't offer you worldwide warranty until you will register yourself for International warranty.

They also provide free replacement,repair & on-site service assistance.
Rate this solution if it was helpful to u.

i ve digi life ddv-7300 model purchased in singapore one year back now its working when shown to service centre they said menu script prob and spare are rarely available. so wat can i do now

Have you cleaned your drum lately. purchase a soft head cleaning tape and run it through there for 20 secs if that doesnt work then you need to send it in for repair.

Hi Everyone,

our MV800 was doing the the same so i "accidentally" dropped it (i got a bit frustrated and it was out of warranty) and now it works fine. please note it dropped about half a meter on carpeted floor while it was off.

Hope this helps

Hello, Sorry to hear that your Canon ZR70MC is not functioning. It would be our pleasure to assist you in being able to capture your once in a lifetime memories again. What is the estimated purchase date of the camcorder? If it is still under warranty the repair will most likely not cost you anything. Camcorder Repair http://www.precisioncamera.com/

yes - your warranty will be voided and cost of parts can be unreasonably high , but if your ' do not shake ' display came on repeatedly ? the door switch may have gone out of alignment during a fall : the canon service manual is available only to authorized servicers so a set of quality jeweler ' s screwdrivers would be needed to . . . void the warranty some more but let you open the cabinets to get at the release mechanism ;

It is a manufacturing defect in a chip. Canon is replacing it irrespective of warranty. See below URL:

http://www.imaging-resource.com/NEWS/1128632808.html

I have had the same problem since I purchased mine 4 years ago and it has been repaired 3x and is in the shop for a 4th. I had the extended warranty and Futureshop refuses to acknowledge that it is a Lemon and should be replaced as they don't consider resoldering wires as a "repair". My unit has been in the service center a total of 12 weeks over the 4 years. The service center recommends Sony Camcorders and the Claim center said they get few Sony camcorders so I would say the Canon problem is an issue that is common. Sorry to say. Mike