Duraband tv code needed for a tvrcsat -rs remote

[PDF]Instructions - ONN Universal Remote Support

myonnremote.com/.../ONB13AV004%20Manual%20Version01.pdf

Mar 28, 2014 - will retain the codes you have programmed for up .... TV/DVD Combo, you might need to set up one ... Point the remote at the audio receiver,.

Faq - ONN Universal Remote Support

myonnremote.com/onn-faq.asp

How do I manually enter codes for my ONN Universal Remote? ... (You haveapproximately two seconds after the device shuts off or begins playing to lock-in the code.) ... so if you need to start the search again, it will pick up where it last left off.Missing: duraband ‎ht395 ‎reciever

RC: Durabrand codes one for all (Page 1 of 2) - Remote Central

https://www.remotecentral.com/cgi-bin/mboard/rc-one4all/thread.cgi?...

May 4, 2006 - 15 posts - ‎9 authors

can you mention the make of the TV??

also what is the model of the remote you are using currently?

0178, 0180 are the most likely codes that will work. I have also read that some people have had success with 0171. Here are the rest of the Duraband codes that you can try if all else fails: 0003, 0154, , 0463. 1034, 0236, 0623, 0493, 1038, 1046 , 1047, 1109.

Hello

Three digit remote codes for Duraband are:-
042/ 053/ 046/ 206/ 805/ 906

Four digit remote codes for Duraband are:_
0189 0135 0157 0051 0189 0053 0227 0456 0042

NB: Switch OFF and switch ON your tv, with its front panel power switch, [NOT BY REMOTE CONTROL HANDSET]; each time before trying an other code.

Direct Code Entry

1. Press and hold the SETUP button until the red indicator stays on, then release the SETUP button.
2. Press and release the desired Mode button (TV, VCR, etc.). The red indicator blinks, then stays lit.
3. Enter the 4 digit code from the code tables. Note: after a valid code entry, the red indicator turns off. For an invalid code, the red indicator flashes.
4. With your device on, press CHANNEL UP. If the device responds, no further programming is required. Note: If some buttons do not operate your device, try one of the other codes for your brand

ok.

Hello Friend,
The codes for Duraband TV are : 0178,0180.
you can also download the user manual from this link:
http://dar.selfip.com/documents/
If the codes don't work for you, you can check in the user manual page 9. it shows another method by searching the code automatically.
Best Regards,

universal remote sharp tu-r160

If the Duraband doesn't work the Philips remote below worked on mine. If it doesn't then it probably is the sensor. I just purchased one of these televisions and it didn't come with a remote. However, a Philips Universal Remote (SRU2103/27)
with a code 0520 works fine. I haven't explored all the codes but I can easily change from tv stations to Video 1 and Video 2 merely by pressing the "Input" button on the remote.

Check this link on OwnerIQ

http://tv.manualsonline.com/ex/thread/view/idThread/57583

You may have to register to get it

If there are no codes listed for durabrand, look to see if the remote has the ability to do a code search. If not it may not operate your TV. If you want the original remote contact remotes.com

try zeinth universal tv remote with code 520 or try duraband's tv code as my tv worked with duraband tv code