Ricoh Aficio 1232c is flashing SC 792

finisher cable not plug into copier. I f you don't have a finisher don't worry about it or you need to remove bridge unit to get rid of code.

SC 792 :Finisher error .The machine does not recognize the finisher , but recognizes the relay unit .Possible causes :Defective connectordefective cable incorrect installation

SC 792 :Finisher error .
The machine does not recognize the finisher , but recognizes the relay unit .
Possible causes :Defective connector
defective cable
incorrect installation

This error code is related to a Insufficient oil.
The fusing oil tank is in the rear of the machine.
You have to call Ricoh to supply the oil.
See you

792 Finisher connection error
Symptom:
The SBCU cannot communicate with
the finisher properly when the bridge
unit is installed.

Possible Cause:
• Poor connection between the finisher
and bridge unit
• SBCU board defective

quick question. do you have a finisher attached to the copier? if not, the message is being shown because of the bridge unit being present, and no finisher.

E721 Sorter stapler bin lift sensor E722 Sorter stapler jogger sensor E723 Sorter stapler grip sensor E792 Sorter stapler error

Hello sir; try to turn off and back on the machine to reset, if don't work next few steps need to follow;
1, press "clear mode" then enter 107 then press and hold "clear/stop" key until SP mode show up.
2, turn power off and back on .

possible toner pump