Error code c8 - Ricoh Aficio SP 100SU e Laser Multifunction Printer Monochrome Plain Paper Print Desktop

The C8 error code on a Power Probe is typically associated with a problem with the temperature sensor. This code is indicating that the temperature sensor is detecting a temperature that is out of range or is malfunctioning.
Here are a few things you can check to fix the C8 error code:

1. Check the temperature sensor: Make sure that the temperature sensor is properly connected and that it is not damaged.
2. Check the wiring: Make sure that the wiring between the temperature sensor and the control board is not damaged or loose.
3. Check the power supply: Make sure that the power supply is providing the correct voltage and that it is not damaged.
4. Check the control board: Make sure that the control board is not damaged or malfunctioning.
5. Clean the temperature sensor: Clean the temperature sensor with a soft brush and make sure it is not covered with debris

ricoh c8 problem solution

Hello Said Raji - Are you certain the error code is C8? Could it possibly be CE? If so, it typically indicates that the dishwasher has detected a configuration error. A professional will need to check the wiring connections between keypad and main control board.

according to the manual...error code 8 indicates a problem with the control panel. here is the link to this manual...page 21 of the pdf http://manuals.electroluxusa.com/prodinfo_pdf/Kinston/154671101en.pdf
Hope this helps you! PS, this model number in the link may or not be similar to yours I had a problem locating your exact machine..so let me know if it isn't the right one and I'll go look some more. meantime...is there another model number on the inside side of the washer door?

my rocoh printer SP 100su show on lcd panal C8 error code . power on .

If there is a set button hold it for 5 seconds.
C8 means that at the rinse phase the boiler did not empty.
The reasons are ..
1) the nozzles are blockled
2)Drain pump out of order
now you must reset c8 from the parameter in order to start again the dishwasher

I think error code C8 is #13
Check following links to see if they have information:

Check following link for recall list:
http://www.tankless-recall.com/tanklessSearch.aspx
Manual shows error 05 or 13:
http://waterheatertimer.org/pdf/Rheem-RTG74IndoorOutdoor_owners.pdf

C8 is the last stop in the point of burner ignition and a total of eight error codes. Error code 12 is a supplemental code that means your LP gas supply is too low...have your LP tank service and try again.

HTH,

Mike...

I think error code C8 is #13
It has to do with air quality, lack of sufficient air, or lack of venting or dirty air filter.
Check following links to see if they have information:

Check following link for recall list:
http://www.tankless-recall.com/tanklessSearch.aspx
Manual shows error 05 or 13:
http://waterheatertimer.org/pdf/Rheem-RTG74IndoorOutdoor_owners.pdf

Remove power source from the unit. If remote control is installed; remove cover and lift the control wires on the terminal...can be accomplished from either end.

Restore power and see if unit functions normally.

Contact Paloma/Rheem customer (800-432-8373) support and notify them IF you are getting a code "76" error. Rheem has recently extended the warranty on the "Burner Control Assm."; which is your problem. The C4-C8 portion of the error code, is where the unit stops the ignition process...burner fails to light, or gives you intermittent hot water. In either case, contact customer support .

If this helps, please indicate so.
Mike//jzklipper