Water problem During the washing time, the clothes get wet and later on also soapy. But i never see a waterline, that the machine is filled half with water. How do i know my clothes are washed clean, without having a problem with the washmachine (ARDO EASY WASH)

If you can provide me with a model number, I can assist you.

Keeping in mind that the soap & bleach gets dispensed into your wash on the second to last rinse cycle and that most all rinse cycles are in cold water. Is your cold water valve screen plugged causing your washer to rinse poorly? Are you using the HE detergent? If not maybe the washer is sudsing up to much and having a hard time rinsing all the suds and bleach out and leaving the clothes soapy.

Fill the washer up with no clothes in it on a cold/cold wash setting does it take a long time to fill the washer up? Also when it is full and agitating is there suds in the washer?

Last suggestion is if the drain is hose is a lot higher than the top of the washer it might have a hard time draining out all of the soap water before the next load

it indicates that the pump is not getting power when on the spin cycle
it could be a blocked hose to the pump, faulty pump( obstruction in impeller of pump) or failed program board not connecting the spin cycle to the pump and water control solenoid.
best have a service technician check it out.

Unplug the washer for 10 minutes and let the board reset. If it still is not filling correctly, then the pressure switch or load size switch is faulty. Appliance Parts Suppliers sells Samsung Parts in Bolingbrook, IL sells samsung parts.

are you packing the washer to tightly with clothes you can overload a frontloader

Clogged water pump. Not draing fast enough. If this is helpful, please post as such.

If you are getting no water spray during the rinse cycle that would cause the soapy clothes issue.

Are you getting cold water during the wash/rinse cycles? If you have the machine set to warm/warm you may only be getting hot water while the final spin is calling for cold.

If you have cold water available then the timer is not calling for the water spray. The problem is either in the mixing valve or the timer.

to much detergent...with theses unit you must use he or low suddsing detergent..take half the wet soapy clothes out then start unit..sud level must fall...

Clean the dispenser water hose ,stuck by liquid dried soup./ the hose going to washer was open during washing time so all soap loaded was gone /
During water refill if nothing water pass to soap dispenser the soap will remain intact / but in washing time all soap will directly washout dispose to drain hose without to clean clothes.

if it wont drain , check your lid switch, check out your motor coupler, if it will not agitate and spin, replace your motor coupler, if it agitates and dont spin, replace your lid switch.

alot of times the washer will drain but we hurriedly cut it off when we hear noise or the water is out but it never spinned and so the clothes are soapy wet...