Intuitive Iw509nw fault code 9 what's it mean please
SOURCE: fault 130 what does that mean on a F&P Intuitive washing machine.
Dear gink,
ngfam1 here for you!
I am happy to be of assistance!
FIX IT NOW BEFORE IT GETS WORSE AND COST MORE!
Here is a good service that I recommend to my customers,
in our 65 year old appliance business!
A&E Factory Service
1-800-905-9505 -(IN U.S.A.)
They are open to make appointments 7days/24hours
A&E is factory authorized service for most brands!
Including warranty work!!!
They will help you, and all will be well!
Good luck!
You will be fine now!
Thank You
Bless you,ngfam1
PS. Pleas egive me a good rating here in fixya.com before you sign out!
SOURCE: Fisher&Paykel Intuitive eco IWL 16 Auto washer Fault code 51
Our washer did the same but it was after I took the excess drain hose and pushed it into the drain in the wall. I thought it looked "more tidy" In doing so I created a siphon effect. Once I pulled the excess hose back out it was fine.
SOURCE: Fault Code 37 Intuitive Washer -
you have a clogged diverter valve, its blue and looks like a Y, it will need to be replaced, if you want call 1-888-936-7872 they can order the part and walk you thru replacing it
SOURCE: top loading intuitive washer says fault code 37
This machine calls this error number for most faults.
So first let us know what stage it stops at.
The most common fault is blockage in the pump.
Remove the power plug, disconnect the 2 water hoses and tilt the machine onto its front.
It is simple to remove and replace. Disconnect the 2 sockets from the pump The pump is held in position by a latch on the left hand side. Depress the latch and twist the pump anti clockwise. Clean out , add a smear of vaseline to the rubber ring.
Reassemble in reverse
SOURCE: Washer Intuitive Fault code 12 Washer keeps
Hello there:
This code is a indication that your water inlet valve has failed and needs to be replaced when these valves fail they will continue to drain water into the machine even if the unit is unplugged
What you can do is to first unplug the machine and turn off the water to the unit then remove the hoses to the machine then youwill need to remove the back panel of the machine so you can get to the water inlet valve once you get to t the valve remove all of the hoses to it and the wiring and remove the valve then you can open up the valve and inspect it and replace any parts that are worn or rusted like seals or seats or simply replacve the entire valve itself this will cost you about 40 to 60 dollars ok once the valve has been repaired or replaced reinstall the water hoses and turn on then plug in the machine and if you have a cancel feature on it press that than you should be good to go from here run a couple of cycles thru it to ensure it is working properly ok
Hope this is very helpful for you
Best regards Michael
243 views
Usually answered in minutes!
×