Sanyo dp42841-01 fuse local - Televison & Video

Your main board needs replacing

https://www.google.com/search?source=hp&ei=c6F3Xpa1H434aZyjvKgI&q=I+need+help+with+a+Sanyo+tv+%26+Sanyo+remote.+I+don't+have+cable%2C+just+need+local+channels.+How+do+I+set+up+for+local+&oq=I+need+help+with+a+Sanyo+tv+%26+Sanyo+remote.+I+don't+have+cable%2C+just+need+local+channels.+How+do+I+set+up+for+local+&gs_l=psy-ab.3...1992.1992..3327...0.0..0.0.0.......1....2j1..gws-wiz.ghRYHbSlS9I&ved=0ahUKEwjWurPazq7oAhUNfBoKHZwRD4UQ4dUDCAU&uact=5#kpvalbx=_MqJ3Xt3JEoyOlwTPvI64Bg33

Unfortunately by applying 120volts AC you probably fried your camera. Hopefully it could be an internal fuse but I doubt it.

Sorry Marty

Clicking noise is usually produced by a shorted load or overloaded SMPS (power supply), black screen as you had mentioned may contribute to a short circuited load.Check voltages (secondary) might be pulsing from high to low that sync the clicking sound.Checking load resistance through filter capacitor will help a lot then try isolating circuit branches to localize the shorted or leaky parts.Try isolating(one at a time) the power supply's loads may help a lot.

The fuse should be located on the power supply board. You'll have to remove the back cover to access it. I posted a link of what the board should look like.

http://www.shopjimmy.com/vizio-aax30284301-power-supply.htm

cant find any belt for my Sanyo SC-H2000,there is any other brand belts that will work with Sanyo

Hello,

Here are the possibilities why your TV will not turn on:

1. Bad fuse
2. Bad capacitors

Bringing your TV to a local repair shop shouldn't cost you that much.

- HotRatchet

try replacing the fuse.there might just be a voltage fluctuation in your locality

http://geeksquad.fixya.com/ThreadView.aspx?prdid=0&thid=748077
Generic problem for all Vacuums
Possible broken belt. Brush doesn't turn
Posted by Helene on Jul 06, 2008
Possible broken belt. Brush doesn't turn on Sanyo Revo SC TA3000 vacuum. Cannot find manual.

Hello,
I would advise you to ALWAYS to FIRST UNPLUG YOUR VACUUM before beginning any service procedure. You can contact the Sanyo factory phone # and or your local vacuum cleaner dealer for the belts. But the owner’s manual you would have to contact the Sanyo factory @ the phone number provided below. If you have further questions please feel free to contact your local vacuum cleaner dealer in your area, or contact the Hoover website and or the cust serv phone # @ Hoover listed below. So if you need further assistance, please feel free to contact your local vacuum cleaner dealer in your area or in the yellow pages, or contact the factory phone number or website to further assist you with your questions.
http://us.sanyo.com/appliances/vacuum_cleaners/
Customer Service – Go to the Contact Us page and fill out the email request
The Service Center Cust Serv Line 1-800-421-5013
Monday thru Friday 7:30 AM to 5:00 PM (PST)
Thanks, Don the Vac Man
Go Ahead. Use Us.

you need to buy the sanyo remote from www.sanyo.com