Door bell sx 29 not working signal - Bell Cocoon Child Carrier

Door ringer is defective or the doorbell transmitter is not sending a signal or the bell is not receiving the signal due to a part failure.

If door is in jammed state, open door by
repeatedly pressing the unlock button, while jiggle the inner or outer door handle this will help free up the
internal gears in the actuator that are jammed.
once the door is open.
Replace the door lock actuator with a revised
part;
Part No.: Description Qty:
96872800 LOCK,LHF DOOR (SX, CX, LX) 1
96872801 LOCK,RHF DOOR (SX, CX, LX) 1
96872811 LOCK,LHR DOOR (SX, CX, LX) 1
96872812 LOCK,RHR DOOR (SX, CX, LX) 1
96872803 LOCK,LHF DOOR (MAXX) 1
96872804 LOCK,RHF DOOR (MAXX) 1
96872813 LOCK,LHR DOOR (MAXX) 1
96872814 LOCK,RHR DOOR (MAXX) 1

Vehicle Torque Spec for door lock actuator
Captiva SX,CX, LX 10 Nm
Captiva MaXX 8 Nm

Hi. Check if the interior light and the door warning signal for the drivers door also do not work. If they don't then the most likely cause would be the drivers door lock itself. Kind regards, Neil

Reboot? Wrong category

the chime is burned out or the door jamb switch not sending a signal to the module wire break inside the boot that cover the wires between the door and body

Sorry but I've got same problem. Keep having to replace batteries in door unit. Expensive!

Sounds silly but this is how i fixed my bell ringing. !st the ringing is the alarm when you open the door and the key is in the ignition or the car is running. I found the push switches that are on the side of the car and are operated when the door is shut have become loose. All you need to do is tighten them up a bit and the bell ringing will stop. When you make your right turn you probably push a bit on the door and that helps open the switch more. The switches are the contact switches that turn on the light as well as the warning sensors for open door. See if your dome lights flicker a bit as well.

i have a 29'' sansui furrato sx , the picture tube is not swithcing on , but itz changing channels, and sound also is ok , can i do anything on my own

Hello,

I work with Silex and can send you the latest firmware release candidate for the SX-200 that includes changes that improves the performance of the unit's wireless radio. Please email me at [email protected] with your full contact information with reference to this post and I can reply with the updated version file and instructions on how to load this file on your unit.

Thank you.

Francis Ponio
Technical Support
Silex Technology America

yes it is true uchange the place of the chime some were elsethats simple. do it. and try