Maytag MAH6500 Neptune Front Loading Washer w/Built in Water Heater Logo

Related Topics:

A
Anonymous Posted on Apr 13, 2017
Be the first to answer

I have a Maytag MAH6500AWW Front loader that from time to time will not drain the water at the end of a cycle. It used to happen every couple months where there would be a little water visible once we took out all the wet clothes, but today it doesn't look like it drained anything... wife got a surprise foot bath!! Once I hit a new spin cycle, it immediately dumps all the water like it should first thing... I removed the pump about a year ago to check for clogs or sludge, but it was spic n span. Thinking it's an electronic issue in the digital controls? Any thoughts? Test procedures? Thanks for the help!

Answer This Question

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Maytag Neptune Front Loader will not go into spin cycle at the end of wash and takes over 1/2 hour to do the last 6 minutes, but does drain the water
replace control module at back right under tut on the base
Read full answer
Dec 12, 2013 • Maytag Washing Machines
0helpful
1answer

Hi, Bought a Maytag front loading washer #MAH6500AWW about 5 years ago. 1. The amount of water remaining in the machine (if you turn the drum it sounds like SEVERAL gallons of water swooshing around)...
i would say the drain pump is blocked.......... you could take the drain hose and leave open end at lowest point on the floor into a container and let water drain out..........easier if you can get machine to outside door and let water drain outside i did a zanusi last night...stuck in the pump was 9 small coins 1 hair grip and a womans bra under wire............
follow the waste hose at the back of the machine it ends at the pump......... open the pump then check it out...
good luck..
cheers
Read full answer
Apr 04, 2011 • Washing Machines
0helpful
1answer

Maytag washer mah6500aww 2003 When I start washer the door lock light comes on then off and on again before it will wash. When time to spin and drain the time goes to zerro and will not drain water out.
u will need to unplug it for about 15 mins to let it reset
Read full answer
Dec 01, 2010 • Maytag Neptune MAH5500B Front Load Washer
4helpful
1answer

My Maytag Neptune front loader always retains water after the rinsing cycle is complete. This has lead to mold in the door gasket and a moldy smell. Is it normal for water to stay in the machine after the...
pump is probably clogged not allowing all water to drain out. Should never see water in the tub at the end of a cycle. About once a month you should run your washer through a cycle with hot water and bleach. Doing that should keep the moldy smell down.
Read full answer
Mar 15, 2010 • Maytag Neptune MAH5500B Front Load Washer
0helpful
2answers

Maytage MAH6500AWW Overloaded washer now leaks when filling
since you can drain it
take off the back and watch what happens when u turn it on
i believe you make have a loose drain connection
Read full answer
Oct 09, 2009 • Maytag MAH6500 Neptune Front Loading...
0helpful
1answer

Front loading Maytag Neptune doesnt drain all water
the washer has a low level of water in it at all times. it will never completely drain out unless you pump it. this is one of the reasons there is such a smell with these washers, i use vinegar in rinse cycle and i use bleach once sometimes twice a month to keep mold and mildew smell away.
Read full answer
Mar 08, 2009 • Maytag Neptune MAH5500B Front Load Washer
0helpful
1answer

MAYTAG MAH6500AWW-WASHER WILL NOT AGITATE/SPIN
Hello,

Check out the motor control board near the floor on the right side. These have a high failure rate on the Neptunes. Maytag redesigned both the motor and motor control board to be more reliable. While inspecting this board, you are looking for a blown 10 amp fuse and /or burnt components. If you have either... then you will need the the new 12002039 motor conversion kit which includes the motor, motor control board and the wire harness.

See http://www.neptunehelp.com/index_files/Page667.htm.

This kit takes about an hour to install.
Don't forget to replace your door latch wax motor. See www.neptunehelpsong.com to hear a funny song explaining the faulty door latch failure.
Read full answer
Feb 07, 2009 • Maytag Neptune MAH5500B Front Load Washer
0helpful
1answer

MAYTAG MAH6500AWW-WASHER WILL NOT AGITATE/SPIN
This is a frontload Neptune. I think you will find that the motor control located in the bottom right front of the cabinet is bad.
Read full answer
Feb 07, 2009 • Compaq Presario 5000 PC Desktop
2helpful
4answers

GE Front Loader Won't complete cycle
My GE Front Loader is 18M old and it has been progressively getting worse, not spinning the water out......I should have known the Pump had a cleanable strainer as Solution #1 says. Pulled a fist size chunk of wet lint, coins, a necklace and wrappers from the Strainer, not to mention about 2 Gal of dingy, soapy water. Tried a Drain/Spin and after a couple of minutes, went to High Speed Spin for the 1st time in about 3 months. Obviously there is a Water Sensor on the Drain Line somewhere that if the Drain Line still has water in it, it does not allow washer to go into Med/High Spin Mode.
Read full answer
Jan 14, 2009 • GE WSXH208A Front Load Washer
0helpful
2answers

Maytag neptune modle MAH6500AWW
it is saying locked rotor situation, could be a loose connection at the main board, at the door switch or the motor is bad, bet motor kit # for motor and board 12002039 good luck with the repair
Read full answer
Apr 12, 2008 • Maytag Neptune MAH6500A Front Load Washer
Not finding what you are looking for?

View Most Popular

MAH6500 Neptune Front Loading Washer w/Built in Water Heater

  • Washing Machines

Related Question

Maytag Neptune Front Loader will not go into spin cycle at the end of wash and takes over 1/2 hour to do the last 6 minutes, but does drain the water

  • Maytag Washing Machines

114 views

Ask a Question

Usually answered in minutes!

Popular Questions

Maytag Neptune Error COde "nd"

Maytag Neptune MAH9700 Front Load...

My maytag neptune front load washer won't spin all the water out

Maytag Neptune MAH5500B Front Load...

Model FAV6800AWW will not pump water out if clothes are in machin

Maytag Neptune FAV6800AW Top Load...

Fabric Softener Won't Dispense

Maytag Neptune MAH6700A Front Load...

HOW TO FIX NF CODE IN MAYTAG WASHING MACHINE

Maytag Neptune MAH5500B Front Load...

Top Maytag Washing Machines Experts

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Brad Brown

Level 3 Expert

19187 Answers

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Are you a Maytag Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

PDF Manual
MAH8700WWW.pdf. user-manual-MAH6500...

MAH6500 Neptune...

Loading...