Light stay on wity message 8.8. but don't do anything before it was resolving with keep dryer time low or high and fix the time some time work but since couple days no respond. just 8.8. stay on none of keys working. Can you tell me is still under warranty or not. My address is 44660 Fenwick dr, Canton MI.48188 Pls help us with the warranty ans. and tip for troubleshooting.Dryer does not operate. 8.8. is displayed but will not turn on. This is a Maytag Neptune MDG5500AWQ DRYER
SOURCE: Maytag Neptune Dryer
is the drum light on while the door is closed?? look on the teck sheet found in the lower front panel for a wiring diagram momery servers me there is a thermal fuse chances are this is bad if you cant find this tech sheet I will look in my invoice book and see if I can find the sheet for it good luck let me know what you find out
SOURCE: Maytag Neptune Dryer making vibrating noise while working
a bearing in the back for your drum sounds like what you describe. It needs to be taken apart and the bearing lubricated with high temp grease
SOURCE: My maytag neptune dryer won't start. The control
Hi,
There can be many reasons why your dryer will not turn...
This tip that I wrote will help you to figure out what is happening...
Dryer Repair - The Dryer is not Turning
http://www.fixya.com/support/r4422207-dryer_repair_dryer_not_turning
Dryer Repair ? The dryer will not start
http://www.fixya.com/support/r4460438-dryer_repair_dryer_will_not_start
heatman101
SOURCE: My Maytag Neptune model MD9800AYQ electric dryer
Hello Jazz,
If the door switch or the door-switch actuator is defective, the dryer won't work and you need to replace the failed component. The switch is inside the dryer main housing near the door frame. Sometimes you need to raise or open the top or front of the dryer to reach the switch.
Thermal fuse
On many dryers, there's a thermal fuse (a heat-sensitive fuse that blows if the dryer overheats) mounted to the exhaust duct inside the back cover panel. The fuse is about an inch long. It's usually embedded in black resin and mounted in a white plastic housing.
If the fuse has blown, it has no continuity. When this happens, your dryer either just stops heating, or it doesn't work at all. Be sure to inspect the venting/heating system before replacing the fuse to put the dryer back into operation. (You can't re-set this type of fuse.)
Joe.
SOURCE: I have a Maytag Neptune
Hello there again you can post me a comment in this section if needed about the dryer ok
Best regards mike
274 views
Usually answered in minutes!
×