Error Code C2500 on a Kyocera KM-2530 - Kyocera Office Equipment & Supplies

https://www.manualslib.com/manual/359935/Kyocera-Km-2530.html?page=1#manual

https://www.manualslib.com/manual/359935/Kyocera-Km-2530.html?page=10#manual

https://www.manualslib.com/manual/359935/Kyocera-Km-2530.html?page=11#manual

http://www.copytechnet.com/forums/kyocera-mita-copystar/20557-kyocera-km-4035-system-error-c2500.html


https://printcopy.info/?l=en&mod=erc&brand=Kyocera&model=KM4035&code=C2500


Kyocera KM4035 Error Codes


Kyocera KM4035 Error Codes

Exploded Views and Parts List Free!

Code

C2500

Description

Paper feed motor problem • LOCK ALM signal remains high for 1 s, 1 s after the paper feed motor has turned on.

Causes

Poor contact in the paper feed motor connector terminals. Defective paper feed motor rotation control circuit. Defective drive transmission system.

Remedy

Reinsert the connector. Also check for continuity within the connector cable. If none, remedy or replace the cable. Replace the paper feed motor. Check if the rollers and gears rotate smoothly. If not, grease the bushings and gears. Check for broken gears and replace if any.

Paper feed motor problem.
Ensure that all cassettes are correctly loaded with paper.
Ensure that by removing the paper cassettes no paper is jammed behind them/in the copier.

press 1087 1087 on the key pad,then 906 then start,then execute then start.
Press 001 to exit.

CHECK THE CARTRIDGE TONER, AND IT REPLACE WITH NEW ONE.

The front door switch or actuator is broken or the door may be warped .Have you tried putting pressure on the front cover? as this may help to indicate if the switch is faulty.

Are you using an after market toner? Sometimes the non Kyocera toner causes light copies?

Go to www.kyoceramita.com for software. Make sure you select the proper software specific to your model and computer operating system.

Try changing print driver and switch emulation to kpdl auto if not already there. If this doesn't work go to properties on driver under font and switch to bit map. Don't do this step unles yo have to it really slows down your printer.

Log into your pc as admin and under the driver properties change from kpdl to pcl5
Its a combo of a problem with adobe reader and the KPDL driver

it's the the expansion card on the main board in the middle, has a yellow circular cmos battery. Either its faulty or popped out during moving the machine. if faulty, replace.