LG WM2455 Front Load Washer Logo

Related Topics:

A
Anonymous Posted on Nov 03, 2013

Wm2455hw front tromm

Door is hard to open and close

5 Related Answers

Anonymous

  • 641 Answers
  • Posted on Aug 21, 2007

SOURCE: "Door Locked" Indicator Switch Faulty

You should access the lid switch (the switch is inside the machine main housing near the door frame) and to see whether it become loose or was broken. Good luck!

Ad

Anonymous

  • 85 Answers
  • Posted on Dec 21, 2008

SOURCE: my front load Tromm LG

oe is an error code for pump problem disconnect power cord open small door on lower front of cabinet pull little tube out and plug from tube and drain water in to bucket after water is drained unscrew cap of pump to clear out any obstructions reinstall the cap and plug and give a test run

Anonymous

  • 323 Answers
  • Posted on May 19, 2009

SOURCE: LG Tromm model WM2455HW front loader walks and

It should have adjustable feet with rubber pads to prevent it from walking.

Anonymous

  • 1543 Answers
  • Posted on Jun 12, 2009

SOURCE: My LG Tromm detergent door is stuck closed and I

Here's what I would do:
Take the two screws off the back plastic parts which are attached to the top cover. Leave the ones in that go into the cover, just remove the bottom one on each side.
Now, standing in front of the machine, use the palms of your hands to sharply push back the top cover (pushing on the right and left edge of the top). It only moves about two inches. Now, lift the cover off.
Use a flashing to try to see into the semi opaque dispenser to determine where the hang up is.
Drill a small hole in the top of the dispenser chamber to allow you to poke an object like a screw driver in to manuver the offending part of the dispenser, allowing removal of the dispenser drawer. Use a peice of foil duct tape to seal the hole you previously drilled.

sodeep

Sudeep Chatterjee

  • 3267 Answers
  • Posted on Jun 03, 2011

SOURCE: i have LG ,Tromm washer

The "dE" error code indicates that the LG Tromm washer's door has not been properly closed. Closing the door firmly usually clears this error. If the error does not go away once the doors closed, a service technician should be consulted.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Front loading washer door should it be left open or closed when no use.

I recommend leaving the door slightly ajar when not in use. That way your rubber boot/door gasket doesn't get smelly or stinky.

-Colleen @ MendingShed
0helpful
2answers

I have the LG TROMM WM2688HWM. Tried to wash a load and keep getting the error message: 'The door is open....'. I have held it closed, pushed it closed, opened and closed many times to no avai

the door actuator may be defective. if ur model has one? other wise sounds like the board is not communicating with the switch


16552665-0ibogqi43422e0jrk2ickvgv-2-0.jpg

16552665-0ibogqi43422e0jrk2ickvgv-2-2.jpg

16552665-0ibogqi43422e0jrk2ickvgv-2-5.jpg

16552665-0ibogqi43422e0jrk2ickvgv-2-9.jpg

by pass the door switch like this:




16552665-0ibogqi43422e0jrk2ickvgv-2-14.jpg
0helpful
1answer

Front door on LG front load is very hard to close

simple just spray on some WD40 if that doesnt work then the hinge its self may be broken if you call LG themselves they will advise you
0helpful
1answer

My LG washer door sqeaks and hard to close

Check the screws on the door might have come loose with use. Or there is the possibility that someone might have leaned on the door. But check the screws first.
0helpful
1answer

I have LG ,Tromm washer machine front load have problem. Door is not closing completely .

The "dE" error code indicates that the LG Tromm washer's door has not been properly closed. Closing the door firmly usually clears this error. If the error does not go away once the doors closed, a service technician should be consulted.
0helpful
1answer

Error message dE

HELLO,

WHAT THIS SIMPLY MEANS IS THAT THE DOOR OF THE WASHER IS NOT PROPERLY CLOSE OR LOCK.

WHAT YOU ARE TO DO TO FIX UP THIS PROBLEM IS, FIRST OF ALL PUT OFF THE WASHER FROM POWER SUPPLY THEN PUT IT ON AGAIN AFTER SOME TIME, THEN OPEN THE DOOR OF THE WASHER AND CLOSE IT BACK AND / THEN MAKE SURE THAT THE DOOR IS PROPERLY CLOSE OR LOCK.

GOOD LOCK AND THANKS FOR USING FIXYA.
0helpful
1answer

How do i get the mold out?

A lot of times liquid detergent and liquid fabric softener will cause this. Dry the door seal after use and leave the door open. Don' t use bleach if you're on a septic system. There are products that are septic safe to clean the mold. Powdered detergent and not closing it up after using should help a lot
0helpful
1answer

"Door Locked" Indicator Switch Faulty

You should access the lid switch (the switch is inside the machine main housing near the door frame) and to see whether it become loose or was broken. Good luck!
Not finding what you are looking for?

44 views

Ask a Question

Usually answered in minutes!

Top LG Washing Machines Experts

Mike Cairns
Mike Cairns

Level 3 Expert

3054 Answers

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Cindy Wells

Level 3 Expert

6688 Answers

Are you a LG Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...