SOURCE: e3 error and treadmill shuts off
One of the safety sensors is reading false. Mainly times this is just a cleaning issue. Remove the lower cover and look for a pickup sensor either,both on the end of the motor or end of the front roller, look for the one that is a disk, should have a sensor with wires leading to the circuit board. try blowing it out with a dust blower or carefully vacuum, it can get bumped and be out of alignment.
SOURCE: treadmill tx400 wont work for llonger then 6 seconds
Sportcraft tradmill are very safe. First check and make sure there are no recalls on you unit. Do that on line or call Walmart where you most lickly got you treadmill. Try lubing you deck wich is under the belt. This is something that needs to be done to stop friction... Frition may have worn down the motor. Get back to me
I’m happy to help further over the phone at https://www.6ya.com/expert/howard_079189dd4959a511
SOURCE: bogs down
Sounds like either the belt is loose or the belt/deck need to be lubed.
To tighten the belt, start by
locating the two bolts that adjust the
rear roller (one on each side of the unit in the back). Run the unit at
about 3 mph. Tighten the bolts a 1/4 turn at a time. Make sure that
what you do to one side, you MUST do to the other side or the belt will
get off center. After you tighten it 1/4 turn, check the belt to see if
it is still slipping. If it is then tighten the belt 1/4 turn again.
Continue until the belt does not slip, but do not tighten the bolts more
than 2 full turns.
To lube the treadmill, use silicone spray and spray between the belt and deck on both sides. I hope this helps. Let me know if you have any other problems.
SOURCE: My sportscraft treadmill TX4.9 shuts down when it shows 3 on the speed
LUBE the deck belt,this happen because the lack of maintenance. may be is time to exchange the drive belt.
2) LUBE the rollers bearings. too
3) measure the input voltage motor, if there are the motor need repair
4) measure the output voltage board, for input voltage motor , if there are NOT the board is faulty. see the b. diagram attached, see my personal TIPS.
God bless you
SOURCE: my sportscraft treadmill stops and displays a 3 on the monitor,what would cause this?
please LUBE THE deck belt, this happen because the lack of maintenance. shut down.for protecting the electronic system
2)LUBE the rollers bearing too very well
3) test the input voltage motor, if there are the motor need repair.
4) adjus the REED swtich, see the diagram , clean it, an tight any connector, or plug.
God bless you
179 views
Usually answered in minutes!
×