Will not go in to spin cycle

A defective cycle timer could cause no spin, no drain.

Could be article of clothing stuck between plastic tub and metal basket. If not that, then most likely clutch or basket drive is bad.

Coupling broken which joins the motor to the gear box. Look and see or listen if the motor is running then if nothing else is working coupling is broke, easy to replace.

First, see the Sears parts site for your washer.

http://www.searspartsdirect.com/partsdirect/getModel!retrieve.pd?pop=true&modelNumber=110.23912100

Also see the Whirlpool (Kenmore) Service Manual for top load, direct drive washers.

https://secured.whirlpool.com/Service/SrvTechAdm.nsf/2cd44500d572193285256a45004fd9d6/f7e2147fa98b28cf85257122007475cb/$FILE/L-55.pdf


The first thing I'd try is using a different cycle. If the washer works as it should, the problem points to the timer.

I'd also check to make sure that when replacing the switch, the connections to the timer haven't come loose.

Since you've replaced the Lid Switch, the motor has power for the drain and spin cycles.

These washers use a reversing motor. The motor turns one way for agitating and reverses for the drain and spin.

Since you cannot hear anything when it is supposed to be agitating, the problem does point to the timer or motor.

your problem still could be a bad lid switch not making. also, check your spin/agitate belt part #40053606. hope the attaced breakdown helps.

Sounds like its a pump problem if pump dosent work the rest of the cycle wont either maybe pump belt has come off or has broken hope this helps

We have a Kelvinator Washing Machine that just won't drain , but fills , agitates , & spins just fine. What shall we do?

your machine needs a new lid switch assembly!

Unless you jarred the machine it's the timer. You can check this by bypassing the lid switch and seeing if it will cycle.

Does the washer fill normally and just stop? Or, does the washer fill, go through a complete cycle, and just won't drain? There could be a couple of problems that cause a no drain issue. 1. FILL NORMALLY & STOPS, WILL NOT SPIN - This is usually a bad lid switch. If you open and close the lid, you should hear a "click", indicating the switch is working. 2. FILL NORMALLY, AGITATES, WILL NOT DRAIN - This could be a clogged drain pump, pinched hose, clogged rain line. Also, you need to make sure timer is advancing properly. If the timer never advances, the washer will fill, but won't go into agitate or spin. Let me know if this is helpful.