10,000 watt generator 220 plug doesn't work

Midwest USA... A working generator in good running condition should sell for around $0.05 a watt +-, so 7500x0.05= $375. Excellent condition add a penny. NOS add another penny.

A working generator in poor condition 3 cents/watt.

A generator that doesnt work, i.e. engine doesn't run or engine runs but no electrical power is $0 to $50. Repair costs of some generators cost more than a new one.

As for operational status, the typical shop vacuum makes a handy load tester. The shop vac load along with a "Kill A Watt" power monitor will provide an independent voltage and frequency analysis.

Be sure to plug the vacuum into every outlet and if any outlet doesn't work consider the unit non-working.

Also if you’re using an extension cord, make sure it’s a 10 or 12 gauge at least...

Any Generator with standard Euro plugs should work in Pakistan.
230 VAC

The capacity will be on a label on the generator portion..not the engine It will say how many watts the generator will produce.

why put a 220 circuit breaker in you electric box and get a 220 outlet plug end on it , easy to do ,

Ez test to determine if stator wiring is ok. This test works on generators that have two sets of 115v plugs and 220v plug. Use a 12v, 1amp ac power supply ( smaller ac power supply should work ok ). With generator not running, apply 12v to one of the 115v outlet plugs. Now verify 12v output voltage with meter at another 115v outlet on generator. Also verify that there is about twice the voltage at the 220 v outlet plug (should be about 20v - 24v) . If the adjoining 115 v outlet plug has no output or very little voltage or if the 220 volt plug has no output, most likely stator is damaged or breaker is off. If the stator is shorted voltage reading will be very low and power supply will heat up. If stator is open, there will be no voltage at second 115v plug or 220 v plug. If voltage is ok at the other outlet plugs as per test above then most likely problem is with voltage regulator, or brushes not making contact or armature winding open or just needs to be energized. Unplug the 12v power supply after test to prevent it from overheating. Most generators have two 115v windings that together power the 220v plug. When you energize one of the windings with the 12v power supply, the second 115v winding will be energized also and give you a voltage reading about equal to 12v. You will not damage the generator with this small voltage being input thru the plug. Good luck

You have to be missing a switch to turn on the power outlets once it is running. That or a breaker needs to be turned on.

Dear J,
I just do happen to live close to their factory.
I pass it often.
Call their factory for your answer, better to call them during business hours.
Here is their number: 1-888-436-3722
God bless your efforts.

sounds like either something is shorted out or the governor is stuck. Check the governor linkage to start with and make sure it is free. Then check the push in breakers for the outlets to see if they are popped. If not the brushes or the armature could be stuck or corroded.

no!   It will be ruined if you try that.