How do I reset the lamp hours timer for this projector? The projector manual says to read the instructions that come with the lamp. The lamp manual says to read the instructions that come with the projector!
This works on a couple different Toshiba models -- might work on yours...
Make sure the main power switch is OFF. Hold the "ON", "MENU", and "INPUT" buttons at the same time and turn the main power switch on. Keep them held until the yellow power standby light comes on, then let go. It is done.
While holding the above keys, plug power cord back into projector, the lamp timer will reset. When power is turned on "0H" appears on the display to verify the reset process.
Make sure the main power switch is OFF. Hold the "ON", "MENU", and
"VOLUM -" buttons at the same time and turn the main power switch on.
Keep them held until the yellow power standby light comes on, then let
go. It is done.
This works for Toshiba TDP T-9
This solution works definately with TLPLW15 lamps. May work for others too.
1. Insert the power cord.
2. Turn the main power switch.
3. Press the ^ button on the control for about 10 seconds. (up button on the remote control). This will make the projector to beep. After the beep, press the V button on the control (down button on the remote control) for about 10 seconds.. This will make the projector to beep again for a bit longer. This indicates that the timer is now cleared.
I managed to get the lamp hours reset. Below is procedure that is required for TDP EW25 projector for future reference.
9,867 views
Usually answered in minutes!
reset lamp timer
i have a same problem, with tdp-s8
Trying to reset lamp hours on a TLP-X10....Any suggestions?
how can i troubleshoot the projector to see if the lamp is bad or do I need to replace the ballast board?
×