Installed new screens and front bezel(cover). The projection is off. Tillted down and to the right. There is black spaces on the left and top. How do I adjust the Projection Module? Model # HL-T5087SA Is there a place to down load the ''Service Manual''?
Okey dokey... you'll need to remove the back cover on this set and make an adjustment to a part called the "DMD board". The DMD board is a large, flat, vertically oriented board with a perforated thin steel cover over it.
Basically, there is a tiny tiny 'tv screen' on the front side of this board and by moving this board around you can 'fine tune' the picture position. All that is typically required is to loosen the screws around the perimiter of the board (JUST SLIGHTLY! You don't want the board to fall out of position!) and slide the board around, preferably with someone watching the screen, until the picture looks perfectly centered.
Something to keep in mind is that the TV will not operate with the back off due to their being a small switch with a blue lever on it whose purpose is to prevent the TV from powering with the lamp cover off. Just tape this switch up so your set will power and then you can rock and roll. Good luck!
252 views
Usually answered in minutes!
×