Generac 010060 mf6500

Check and change the oil

Judy, Generac portable generator oil recommendations. Above 40°F, use SAE 30. Below 40°F and down to 10°F, use 10W-30. Below 10°F, use synthetic 5W-30. Oil should be changed after the first 8 hours of operation and every 200 hours of run time thereafter.
Check the attached links,instruction and guides, Good luck
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."

http://www.generac.com/service-support/faqs/portable-generator-faqs

http://www.generac.com/service-support/faqs/home-backup-faqs

Best oil for Generac generator Lawn Mower and Small Engine Bob Is The Oil...

Generac Generator Oil Change

Look in the owner's manual. If you don't have one, check Generac's web site and download one. There should be a drain plug at the bottom of the crankcase.

There is no way to reset it manually. It resets automatically after you run it a few hours.

if the gerator runs pretty smooth up until then, i would suggest checking/changing your oil as the low oil level switch is picking up on a slight change in the oil level (easier to detect when oil is hot), if it start to give hesitation or reduction of power, check the choke, make sure its off.

plain 30 wt is fine.

There is no mention of a fuse in the index.
I just read the manual and the SYSTEM ERROR 010060 is a Primer Motor sensor problem, Sensor might be bad, motor might not be turning, cable could have failed, or main PCA might be bad.
I uploaded the manual for you, here is the link:

http://rapidshare.de/files/47323187/HP_DeskJet_70-75-755_Service_Manual.pdf.html

Click on this link or copy and paste the complete link into your browser.
If I could be of further assistance, let me know. If this helps or solves the issue, please rate it.
Thanks, Joe


I’m happy to assist further over the phone at https://www.6ya.com/expert/joe_8b8c2cd6ce148309

I am assuming the generator worked fine before the oil change. Now that you have done the oil change the genset does not start. These generators have a safety switch, which is basically an oil pressure switch that keeps the engine from running when there is not enough oil in the engine. Make sure that there is enough oil and if there is, look for a wire that runs along side of the engine to a round component. disconnect that wire and try starting. If it does not start then try to ground out the wire to the engine block. If this does not work, then there is other engine problems.