Panasonic PT-53TW53 53" Rear Projection HDTV-Ready Television Logo

Related Topics:

M
Michelle Stachowiak Posted on Jan 02, 2014

I turn on our phillips Model 60pp935217 and ablus screen comes on for like 2 seconds then goes black. Any ideas what might be wrong? Or is the TV junk

Blues screen then turns off after like 2 seconds.

5 Related Answers

Anonymous

  • 277 Answers
  • Posted on Dec 26, 2005

SOURCE: Big screen tv broken

If you're NOT still under warrantee you should at least open the TV and look for a blown fuse near where the power cable enters the set. A lot of times you can buy replacement fuses at a local electronic or hardware store and they're easy to replace. Check the fuse. If it is blown, it will be obvious and make sure that the set is unplugged before replacing it. If it blows again, or if it is not blown, your problem is probably in the 'X' volt regulator and you will need professional help with the repairs. You can also check the board where the components are mounted and resoled any that look bad. Brief power outages may cause the TV to turn off on its own. If you are using a surge protector, try connecting the set directly to the wall outlet. In your case it could caused by a blown fuse, a leaky diodes or a bad solder joint at the horizontal drive transformer. All can be replaced at a local electronic or hardware store and they're easy to replace If this does not correct the problem, you may need to have your TV serviced. good luck!

Ad

Anonymous

  • 1153 Answers
  • Posted on Aug 12, 2007

SOURCE: 47 inch Pabasonic Project T.V.

This could be part of the text mode, which has to do with the caption. Check and see if it's turned on.

A

Anonymous

  • Posted on Aug 09, 2008

SOURCE: Tv display black bar in the middle of the screen

I battled with this for a while before I realized that my 18 month year old had somehow turned on one of the less common closed caption modes. Since the mode was not supported, it just displays a black frame over most of the screen. Just turn it off and you are good to go.

Anonymous

  • 2920 Answers
  • Posted on Oct 26, 2008

SOURCE: tv wont turn on

your power supply is bad and needs replaced

Anonymous

  • 25 Answers
  • Posted on Jun 11, 2009

SOURCE: Screen is fine when I first turn on TV, then goes black

Sounds like you dlp lamp is going out. That's a pretty old TV and if you are still running on the stock lamp this is exactly the type of thing that will happen. The lamp model for this particular tv is the ty-la1001. You can find that over here:

http://dlplamps.com/products/panasonic-dlp-lamp/panasonic-ty-la1001.html

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1helpful
1answer

What should i do, half of my tv screen goes black when i turn it on then it shuts down 3 seconds later?

The T-con board is bad. You can easily replace this board with simple hand tools(Phillips point screw driver). You can go to this web site to get the part you need. TV Parts Universal TV Stands DLP Chips ShopJimmy
1helpful
1answer

How can i fix my Philips model 42PFL5432D/37 Flat screen TV that powers on, but no picture.

The main board to your TV is faulty. It is best to contact the authorized service center for Philips; because, it will be very difficult to get the main board to Philips brand TVs, and after the replacement, a firmware update too will be necessary. This is a skilled work. http://electronicshelponline.blogspot.com/
1helpful
1answer

Phillips 409fl7505d/f7

I once had a problem with a Phillips tv.It was less than one year old and one day ,all of a suddenm a black screen came up.I elarned it was called the "black screen of death" and that other people had gone through the same thing.Someone online had actually written to Phillips and they had gotten a new TV form them,so I tried the same thing and amazingly,Phillips gave us a new TV and came and took the old one.The enw worked fine. So you may have a lemon on your hands.Unfortunately, I do not have the letter I sent to them but the replacement they sent me was part of their "Rapid Replacement" program.This wa sin 2008 so I'm not sure if they still ahve it but it may be worth a try.
0helpful
1answer

Phillips 47PFL3603d-f7 blinks when turned on

Common short the cover cap over the video & sound boards short out if you remove it the cap only (shield metal) it usually will fix this
10helpful
1answer
0helpful
1answer

When i boot up my desktop the monitor comes on then goes off, it come back on momentarily when windows starts up and then goes off again. i can turn the monitor power off then on again and it comes on for...

Your backlight might be dead. Try using a flashlight to see if you can see a screen
when it turns black. If you can, its a backlight problem. What model of screen do you have?
0helpful
2answers

Phillips 60pp935217

I have a phillips HDTV monitor model 60pp935217, i don't get an hd picture but i do have sound. Please help.
1helpful
1answer

Projection screen tv trouble

sounds like your projection lamp has blown..

 

Not finding what you are looking for?

119 views

Ask a Question

Usually answered in minutes!

Top Panasonic Televison & Video Experts

 Grubhead
Grubhead

Level 3 Expert

5755 Answers

Grand Canyon Tech
Grand Canyon Tech

Level 3 Expert

3867 Answers

Cindy Wells

Level 3 Expert

6688 Answers

Are you a Panasonic Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...