Question about Quinny Buzz 3 Stroller

1 Answer

Quinny buzz 3 seat unit

Seat unit won't click in to chassis on right side (problem is with seat rather than frame as have tried both parent and forward facing). What could it be?

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Quinny Master
  • 1,637 Answers

Hi Laura,

Unable to advise what might be causing the issue without being able to see the product.

If you're in the UK and the product is under 2 years old, please contact your retailer with your proof of purchase and they can arrange for it to be sent to our engineers for inspection / repair work required under warranty.

If you're in the UK and the product is over 2 years old or you no longer have proof of purchase please contact the customer care team on 01284 413 141 Mon-Thur 08:30-17:30 / Fri 08:30-16:30 (Excluding Bank Holidays) to discuss booking it in for chargeable inspection / repair work required.

If you're outside the UK please visit and select the country you're in, then use the "Contact Us" tab on the right side for your enquiry to be sent through to the customer care team in your country.

Posted on Apr 24, 2014


5 Suggested Answers


  • 60 Answers

SOURCE: quinny buzz 2006- if i got a new frame would the

Yes it will

Posted on Aug 17, 2009


Liz Wanden

  • 419 Answers

SOURCE: Removing a maxi cosi car seat from a buzz 3 chassi


On the Cabrio Carseat, at the bottom of the handle (when in the upright position) there is a silver button (either side) this would be roughly where the babies hands would be if out-stretched), depress these buttons and the Cabrio should release fine. DONT do this when baby is in the Cabrio whilst you are practicing. If this is a little stiff, when you have released the Cabrio, WIPE a little WD40 (sprayed onto a cloth) onto the adapters, DONT spray it on. This should make the release a lot easier in the future.

I hope this helps.

Posted on Sep 14, 2009

Liz Wanden

  • 419 Answers

SOURCE: will a quinny buzz seat 08 unit fit a quinny buzz


As far as I know the answer is yes, but I suggest that you see if you can get hold of a 2008 seat frame too as these were slightly adapted to stop the seat from tilting so far back.

I hope this helps.

Posted on Oct 11, 2009

Testimonial: "thank you very much i have contacted dorel and they are sending me a replacement one. thanks again"


  • 10 Answers


Not as far as i know

Posted on Feb 24, 2010


  • 15 Answers

SOURCE: can a buzz seat fit speedi frame

No unfortunately not. The Quinny Dreami carrycot can be fitted as can a maxi cosi car seat using adaptors but not the buzz seat unit.

Posted on Jul 27, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I have a 2005 model Quinny Buzz and tried my chassis with a newer model frame. The only difference in seat frame to chassi conection is the format on the tip of the pole that ataches to the chassis. Mine...


This is not recommended as modification of your Quinny could make the product unsafe to use.

From what you are saying you are trying to use the original 2005 style chassis with a newer model sub seat (seat frame) is this correct?

If so there are rubber bungs on either prong on the sub seat that can be removed in order for this model sub seat to fit in the 2005 chassis. If you'd like more information on doing that please pass on an e-mail address and we can put you in touch with an engineer to discuss.

Mar 23, 2013 | Quinny Buzz Baby Gear

1 Answer

How to put quinny rear facing


To remove the seat unit, push down the grey levers on either side of the seat and lift it off the chassis. Now place back onto the chassis facing the other way. You can get a copy of your user manual from the Quinny website if you've lost your original

Feb 01, 2013 | Quinny Buzz 4 Stroller - Racoon

2 Answers

How do i attatch the quinny zapp xtra seat to the quinny zapp frame

Yes the new seat unit can be used with old zap.You remove the fabric seat (look on u-tube if you don't know how)the new seat unit then fits on to frame via the addapters that come with the xtra seat unit, at the point where the car seat addapters fit.There is a large push button on the top of the seat unit which you push in to recline or sit up the seat, and a little one too next to it, that needs to be pushed away from the larger one, while you hold the large button down when you want to remove the seat unit.I found fitting the xtra seat very easy.To fold the zapp you Must remove the entire seat unit as it won't fold with it on, unlike the old one.

Nov 30, 2011 | Quinny ZAPP Stroller

1 Answer

How do i turn the seat on the quinny buzz so that its parent facing?

The seat is lifted from the chassis and re-fitted in parent facing position.
To remove the seat from the chassis, press down on the grey buttons either side of the seat unit.

Sep 16, 2011 | Quinny Buzz 4 Storm Stroller

1 Answer

Its not my stroller but i need to put it down to put in my car can you please tell me how to put it down.

Good Afternoon

If the seat unit is on the Buzz, you'll need to make sure its in the forward facing position and upright. Now stand in front of it (this is the easiest way of folding the Buzz). Press the button on your left side at the knuckle in - and the grey chevron-marked button on the your right twists forward toward you. Now apply a gentle amount of pressure and the chassis will collapse down smoothly. Ensure the transport lock is applied for safe travel. Remember that if there is any kind of resistance or the chassis makes any kind of clicking noise that you should not continue attempting to fold as the buttons have not been fully engaged for folding.

Apr 28, 2011 | Quinny Buzz 3 Storm Travel System Stroller

1 Answer

I have a quinny buzz 2005 frame will a replacement seat unit fit this and will the carry cot fit please

Good Afternoon

The original Quinny Buzz 2005/2006 chassis is not suitable for fitting the current seat fabric. However you can purchase a sub seat (seat frame) which will fit onto your chassis (RRP 75GBP) and the current seat fabric will fit onto that (RRP 40GBP). The Quinny Dreami carrycot is suitable for use on any Quinny Buzz chassis. You can order the sub seat and seat fabric via your local Quinny retailer or direct from the customer service department on 01284 413 141 Mon-Fri 8.30-4.30.

Jan 11, 2011 | Quinny BUZZ 3 Capri Stroller

1 Answer

How do i fit the seat on the frame

It's a bit of a black art! Frame must be fully open to fit seat unit, then the seat unit should side straight down those two guide posts to a nice double click sound. Yeah right! Keep wiggling you'll get there.

Dec 27, 2010 | Bugaboo Gecko Stroller

1 Answer

Dreami - Black Bassinet: I've just bought a Quinny Freestyle and would like...

Yes you can. You need a set of adaptors( the same ones as for attaching a maxi cosi car seat) You remove the seat unit by unbuckling all straps and taking it off. Then you then need to remove the 2covers above the quinny logo on the sides of the pushchair frame. You do this by pressing the silver buttons to release them and then they should slide off. You then replace these with the adaptors for the carrycot. These slide into position until you hear a click. They are marked left and right. The carrycot is then placed onto these(again it will click on) parent facing. To remove the carrycot you then press on the silver buttons on the carrycot unit and lift off using the handle in the carrycot hood. HTH

May 18, 2010 | Quinny Dreami - Black Bassinet

1 Answer

Our quinny seat is currently facing 4ward and we wld like it to be facing towards me when pushing it

The buzz is very simple to use. The best way to do it is to recline the seat unit into the lie flat position using the grey buttons at the side of the frame and then using the same buttons, while holding them both down, lift off the seat unit, turn it round to face the opposite way and then click it back into place on the frame in exactly the same way. You will them be able to recline the seat up or down in the same way as you would while facing the other way, however I think there are slightly less recline positions while facing one way but I can't remember which way! Hope this makes sense!

Mar 05, 2010 | Quinny Buzz Three Wheel Stroller

2 Answers

How to fold a quinny buzz

Hi, you can download the manual from the quinny website, but as a quick guide, the best I found was - first stand with your foot against the front wheel (so it doesnt move forward) then press the grey buttons on either side of the chassis and at the same time draw the frame downwards towards your foot, please remember you can only fold down with the seat in place if the seat is facing forward (ie baby facing outwards) it wont fold down with the seat facing mum, there are also demos on you tube, hope ive helped and not been too complicated :)

Oct 08, 2008 | Quinny Buzz Jogger

Not finding what you are looking for?
Quinny Buzz 3 Stroller Logo

Related Topics:

53 people viewed this question

Ask a Question

Usually answered in minutes!

Top Quinny Baby Gear Experts

ray gallant

Level 3 Expert

66490 Answers


Level 2 Expert

47 Answers

Tom Chichester

Level 3 Expert

55370 Answers

Are you a Quinny Baby Gear Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides