Operating of samsung WF-B1061 washing machine

The drain filter on the Samsung model WF 328AAW/XAA is located behind the lower kick panel. To access it, you'll need to first unplug the washing machine and shut off the water supply. Then, you'll need to remove the lower kick panel by removing the screws that hold it in place. Once the panel is removed, you should be able to see the drain filter. It's a small, circular filter that is located near the base of the machine.
If the drain filter is clogged, it can cause the washing machine to not spin or drain properly. To clean the filter, you'll need to remove it and rinse it under running water until all of the debris is removed. Then, reinsert the filter and replace the kick panel.
If the drain filter is not the problem, there could be other issues causing the washing machine to not spin or drain. Some other possible causes include a faulty drive belt, a malfunctioning drain pump, or a problem with the control board. If you're unable to diagnose and fix the problem on your own, you may need to call a professional appliance repair technician for further assistance.

NF and 4E = No Water Feed = Washer Not Filling. This means that there is an issue that is preventing your washer from receiving water into the water inlet valve. The troubleshooting steps below apply to all types of Samsung washing machines including front load, top load, and washer and dryer combos

https://removeandreplace.com/2015/12/16/samsung-washing-machine-shows-nf-or-4e-error-code-what-does-this-fault-code-mean

Hello,

6e error mean heater not functioning. Check the heater element and if is bad change it. If the heater element is ok, check the connection to electronic board.

All the best !

does it show an error code ? when it trips what is the washer doing filling water or spinning etc ? does it work on other settings like spin and drain with out tripping. ?

Here is the owner's manual:


http://www.manualslib.com/manual/147752/Samsung-Wf-B1061-User-Manual.html?page=10#manual



It says in troubleshooting section error 4E is a water supply issue. The screens on the watervalve may need cleaned. Remove supply hoses on back of machine to clean them. If no improvement check water pressure coming from supply hoses. If pressure is good watervalves may need replaced.

DE is a drain error/
Your drain pump is blocked with lint or is defective.
Open the drain pump and clean it out.

i have a samsung washing machine, no power in my washing machine and i couldnt find in side any fuse, can you tell me what is the problem it? thanks

sir
my washing machine WF-T6517TC
when it start to wash get Alarm "dE" beep and stop machine.
what need to do.
call me 91080843

Either a main control board or you have a drain line problem causing the water to siphon out. If you house drain is lower than the washer water fill line or if your drain hose is sealed into the house drain line then you can have the water siphoned out of your washer. Check to make sure the drain line is not to far into your house drain pipe and that there is air around the drain hose where it enters the drain pipe, (not sealed tightley). If it is not the drain siphoning then you need a technician to diagnose the main control board and to replace it. Good Luck Appliance Specialists