The printer (Ricoh Aficio CL7100) says it's warming up, but doesn't make any sounds like it normally does, and doesn't get past saying warming up.
You need check:
1) there are two fuses in the fuser unit, big possible one of them broken. change fuse if you can, should be fixed.
2) if check (use meter) all fuse good, so the heat lamp damaged,
you may change it also can fix it,
fuser unit maybe expansive.
hope hep you fix it, please feedback any question any time, pleaae take a rating let me know how much helped you thanks!
188 views
Usually answered in minutes!
There is no error message, it just says Warming Up....
And turning it off and unplugging it doesn't help either.
I'm having trouble understanding you. Could you try asking it again?
Thank you.
The fuser is not hot, took it out, the printer recognized it wasn't there, but nothing changed when put it all back. Even tried turning it off and back on, and still same problem.
you may check fuser after running, is it very hot?
take out the cartridge shake it properly reseat it. see how?
just make a sense:
1) cartridge run can not ready
2) fuser run can not ready which heating trouble
check it then tell me please
is there any error message show on?
×