Broken cable connector

If you wish to get some details; check the site linked here. Pull up older posts. Surf the site with patience. http://electronicshelponline.blogspot.com/
Disassemble procedure to many popular TVs are given; with illustrations. You can get details there.

Hello,there are few reasons for a problem you have:
1.check the cable of your power suply-maybe its broken
2.break in the solder connector(for power cable)
3.some of cells at your battery are short circuit
4.the worst solution is the faulty chip,for charging controll

Hello!

This sounds like the monitor is either:

1. Plugged in wrong
2. Unplugged
3. The monitor has a bad cable or cable connector
4. The connector on the back of the case is broken

The way to test this is to check each of the problems listed above. Good luck!

Hello i ran into this problem twice with a Toshiba and a hp what i did was go through my parts found an old laptop keyboard and cut the ribbon cable from that folded it over to make it twice as thick and worked it into the groove then i slid a piece of credit card into the middle of the folded cable like a sandwich the credit card shim was the meat and the folded ribbon cable shim the bread put a piece of tape on top to keep it secure never a problem take a breath think about it and dont use force or glue the mind is a powerful thing use it this does not mean mother board replacement

Hello,
If you are connecting the projector to the signal source via S-VIDEO cable this not uncommon. It usually happens when one of the connectors or the cable is broken. Try a new or different cable. If problem persists examine the connectors on both end of the cable and the one in the projector as well as the one in the signal source(pc, laptop etc) to see if there is a hardware fault. If all is good then the problem is internal with the S-VIDEO connector. In that case your other option is to use VGA.
Have a good day, hope this helps.

Tv fell off about 3 feets or more?Yes,turn on the tv see if u getting any power to the unit?Might have broken main PCB board too.If unit still have power,check see if tv get statics screen have colors shaded in red or mutiples colors,mean the tv CRT(tv tube) yoke is dead and damages scrambles radiation.Or the tv getting power but have high pitch sqeeling noises or rattles noises,tv have the CRT-(tv tube) is crack by the neck or broken totally.CRT have damages problems or dead tv is worthless,beacause of CRT(tv tube) is dead,not fixable even that antena connector input is replaced.

http://www.allpinouts.org/index.php/Main_Page

Hello sounds like the coaxial connector has come off or broken off the tuner, You can repair this problem using the old connector that broke off by taking out the tuner and resoldering the center pin back to the tuner board (provided the small tuner board is not cracked) and the out side of the connector to the tuner housing for ground. If you are just using or referring to a common coaxial cable to purchase, you can get these from everywhere Radio shack, Fry's etc. Also ur local cable company. If all else fails use the rca output jacks from the cable box if u have one and connect it to video input one on the back of the television, make sure you change you television input to video one if u decide to do it this way.

hello

This different color thing happen due to only loose connector, either at the LCD end or at the mother board end.

so if you have some experience with hardware you can open up and check the connectors and see if they have to be replaced or just need to fix properly.

Thank you

Usually the connector or at least a new connector can be put back on. If there is minor damage to the board, a tech can repair it in most cases.