My icemaker, a ge profile is only making crushed ice, no cubes,

Replace the bin. I think if you inspect it, you will find some plastic broke off of it.

This is normal if you have previously used the crushed ice mode. The refrigerator will continue to dispense crushed ice for some time until the reserves are depleted. If this continues for a longer period then shut down the refrigerator and remove the dispenser compartment, clean any remaining ice and reinstall it. Start the power supply and wait 5 hours for the ice to form. Use the cube mode and you will surely obtain ice cubes.

Sounds like the piece which lifts up the crush/cube actuator behind the ice bucket . Will have to be replaced with 1 piece (plunger AND actuator ) .

I have the same problem. My GE refridgerator won't dispense ice cubes.

I have a GE TFX25ppbaaa refrigerator. The ice maker corkscrew motor would run and provide crushed ice only. The corkscrew motor would not run when the switch was moved to the cubed ice ( half moon) setting.

I replaced the large Light/ water/ crushed ice/cubed ice switch , ( product service number GEH WR55X129 ) ( part number GE 162D6372 PO17 )and it fixed the problem. Cost was about $43.00.

Replace the switch behind the front panel on the freezer.

the switch or the bin

make sure the switch is turned on on the icemaker if it is then see if there is water in the icemaker it could be either water valve or icemaker

Pull the ice bucket out. Behind it you will see a rectangular hole with a rod in it. The rod should be able to move with your one finger up and down. If it does not, the solonoid attached to it is either frozen or burnt out.

Unplug it for around 30 mins. then plug it back in and see what happens. Try this before anything.