Error code 125

turbid water!

Whirlpool Dishwasher Error/Fault Codes - eSpares

https://www.espares.co.uk > Advice Centre > Dishwashers
FA (or 11 flashes) - Optical water indicator (turbidity) ... This fault indicates an error with the sensor in your machine that monitors the water cleanliness. If ...

Whirlpool Dishwasher Error Codes - Lights Blinking Flashing

https://removeandreplace.com > ... > Dishwasher Repair
Mar 9, 2016 - Some Whirlpool dishwashers display an error code by flashing the clean Light on the display in a pattern.

Whirlpool ADG 7560/2 pumps in water, then beeps with error ...

https://www.reddit.com > Whirlpool > comments > dish...
3 days ago - Dishwasher - Whirlpool ADG 7560/2 pumps in water, then beeps with error and 11 flashes. My dishwasher started faulting.

..

In the instructions for different models of Bosch dishwashers, the e27 error is described as insufficient voltage in the electrical network. This means that if the mains voltage drops below 220V (or 110V in some countries), the dishwasher stops working, and the E27 error code appears.

Hi Roger, Hope this helps......CHEERS..

KENMORE DISHWASHER ERROR CODES

Kenmore Dishwasher Error Code = Start Resume light blinking slow
When the dishwasher door opens or electrical power is removed during the cycle then the dishwasher will not start again. The door is detected as being closed and the Start Resume button is being pressed
Kenmore Dishwasher Error Code = Clean light is blinking 7 times
Heater circuit fail. Control panel did not detect the water getting hot. Did not detect heating element was energized to heat the water during the wash cycle
Kenmore Dishwasher Error Code = Sanitize LED blinking at end of cycle
Control panel could not detect if sanitation has been achieved
Kenmore Dishwasher Error Code = Console light blinking rapidly
There is a stuck button on the control panel
Kenmore Dishwasher Error Code = Clean light is constantly illuminated
Dishwasher cannot start a wash cycle until it sees that the door has been opened after the previous washing cycle
Kenmore Dishwasher Error Code = Control lock LED is ON but not responding to pressing of the keys
Turned on by accident or there is a control detected key pad problem

Don't know enough from your description. Does the pump hum, or empty the washer? There's a strainer under the lower washer arm that may be plugged. If the pump doesn't engage at all, my first thought would be the timer portion of the control board. I'd guess the control board would run about $125 or so.

No the NTC is not faulty... But I could be wrong.. Check this site for error code

Error 20 is not a listed error in Baumatic dishwasher. They only mention E1 to E7.

There is a reset procedure for random errors which can be viewed at this page.


http://www.ukwhitegoods.co.uk/help/fault-codes/dishwasher-fault-codes/3305-baumatic-bdw-dishwasher-fault-codes.html

Please check if this helps.

ring Yamaha dealer they will tell you what the codes mean.

Hi there,
The most common cause of an OE error code on a modern LG dishwasher is:
1. Blocked drain hose
2. Obstruction in the sump area (beneath the filter, which needs to be removed to check for onstruction)
3. Failing drain motor. 

else you need to REPLACE THE PCB POWER CONTROL BOARD

Good Luck!!!

After leaving the dishwasher locked with the error code still showing, I returned to find that it had reset itself and run through the full cycle.
Problem solved itself.