Question about Mitsubishi WD Televison & Video

1 Answer

Tv wont come on blue light will flash when resetting but after that status indicator just blinks

Tv was working fine when turned off turned on the next day and it would start to come on but then went blank and status indicator would flash orange tried resetting and it did the same thing . I also trie a new bulb and now when I plug it in the status indicator just flashes tried resetting again and the blue hd light will just flash and the status light continually flashe orange any suggestions ?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Renaissance:

    An user who is expert in 3 categories / brands.

  • Master
  • 829 Answers

I happened the same problem and the solution must change the power pack

Posted on Jan 25, 2014

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Anonymous

  • 1 Answer

SOURCE: Mitsubishi WD-62525 yellow blinking status light

Check that the lamp door is closed all the way. There is a saftey switch that closes from the door being on all the way. If not the status light will keep blinking. There is also a switch on the air filter door.

Posted on Jul 16, 2009

Anonymous

  • 1 Answer

SOURCE: Power button Flashes

Bad Convergence circuit , replace 2 STK392-110 & fuse will take care the problem

Posted on Jul 18, 2007

Anonymous

  • 1 Answer

SOURCE: Power light flashing/ no picture

I have the same problem. The only way to get the TV to come on is to unplug it, but once you get it back on it turns itself off again in a few minutes.

Posted on Jul 19, 2007

ctf1800

Cary Farah

  • 4402 Answers

SOURCE: jvc 52 inch hd-ila hdtv widescreen

you have a bad lamp or balast

Posted on Jan 22, 2008

Anonymous

  • 1 Answer

SOURCE: blinking green light, will not power up

my 55613 tv wont turn on just blinking green light

Posted on Sep 19, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Battery light flashing orange


Your battery may have Battery charge status indicator, when you press the button next to the 4 led indicators the LEDs indicate the charge status.
Also the System Battery/Charge LED indicates the battery's current operational condition.
Flashing orange indicates Battery failure.

May 25, 2012 | Dell Inspiron Mini 10v Netbook Computer

1 Answer

My NEC vt 595 was working fine last night and today i went to turn it on the status and power light started flashing red and orange and there is no picture


if Power is flashing orange - then it's cooling down

if Status is flashing red - then there are 4 flash combinations.
1 cycle (0.5sec On, 2.5sec Off) lamp cover or housing error
2 cycle (0.5sec On, 0.5sec Off) temperature error
4 cycle (0.5sec On, 0.5sec Off) fan(s) error
6 cycle (0.5sec On, 0.5sec Off) lamp error

Which is your condition?

Mar 18, 2011 | NEC VT595 LCD Projector

1 Answer

WD57732 purchased 12/06 and has worked fine. Turned off at 11 pm last night. No indication of trouble. Tried to turn on this morning and nothing. Did TV Reset, green light flashed for a minute like it...


Now,tv on?.Tv "LAMP" LED light indication flashes or stay on?How long the Lamp been inside this tv,been inside like 1 1/2 or 2 years and tv been on each day like 4 or 5 hours a day in used.The lamp life are over.Should replace another lamp.

Dec 10, 2010 | Mitsubishi WD-57732 Projection Television

3 Answers

Battery indicator flashing red when running on battery or on main supply and battery is 75% charged


When your battery indicator is flashing Red, it usually means that the charger is defective.

Dell also had a recall on some of its batteries. To see if you qualify for a free replacement click here: http://www.dellbatteryprogram.com/

If you want to reset your battery utility follow these steps:

1. Let the battery run completely dead. (Make sure all your work is saved)

2. Fully charge battery (You may still have flashing lights but if you turn your computer on and enter BIOS you can see the charge level)

3. Once again run battery dead.

4. Remove battery and wait 5-10 minutes.

5. Replace battery and use in normal operation.

If you found this information helpful, please give me a big thumbs up when you rate my answer. Thanks!

Feb 03, 2010 | Dell Latitude D600 Notebook

1 Answer

Orange LED indicator on the "Power Ring"


From the sounds of things you have a bad RF Board. This is the board that controls the syncing of your controllers, as well as your ring of light. If there is someone in your area that fixes the RROD they may be able to replace your RF board as well. I'd be happy to do it, but shipping would be almost the same cost as the repair. Contact me at Jordan@jordanselectronics.com for more info.

Jan 09, 2010 | Microsoft Xbox 360 Console

2 Answers

Dell LCD TV won't turn on


check the cable who comes from the cpu

May 07, 2009 | Dell E173FP 17" LCD Flat Panel Monitor

2 Answers

VT440K orange power flashing red status light, overheated.


Make sure all the air filter caps are all the way in and nothing is broken from it. that was my cause..i had the same problem

Apr 17, 2009 | NEC (50019497) Projector Lamp for VT440,...

1 Answer

I have a LG RU-44SZ61D DLP TV and recently replaced the bulb. After about two months the TV went really dim and then started shutting off. The problem increased to the point where you couldnt have the tv...


DLPs have flow chart trouble shooting techniques to pinpoint exactly why your set isnt completeing the boot sequence. If you would like the service manual for your model let me know and i will post a link where you can purchase a complete one.

Apr 06, 2008 | Televison & Video

1 Answer

Power button Flashes


Bad Convergence circuit , replace 2 STK392-110 & fuse will take care the problem

Jul 18, 2007 | Hitachi 43FDX15B 43" Rear Projection...

Not finding what you are looking for?
Televison & Video Logo

Related Topics:

225 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Televison & Video Experts

matt martin
matt martin

Level 3 Expert

1257 Answers

The Knight
The Knight

Level 3 Expert

76177 Answers

Ekse

Level 3 Expert

13434 Answers

Are you a Mitsubishi Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...