Hoshizaki Freezer Commercial Ice Machines - KM900MRH Commercial Ice Machine Logo
Posted on Jun 03, 2009
Answered by a Fixya Expert

Trustworthy Expert Solutions

At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.

View Our Top Experts

Small production of ice? What should be the normal production of ice?

The km 450 mab is producing a small amount of ice. What is the amount it should be producing? Kathy

2 Answers

Anonymous

Level 1:

An expert who has achieved level 1.

Corporal:

An expert that has over 10 points.

Mayor:

An expert whose answer got voted for 2 times.

Problem Solver:

An expert who has answered 5 questions.

  • Contributor 16 Answers
  • Posted on Jun 23, 2009
Anonymous
Contributor
Level 1:

An expert who has achieved level 1.

Corporal:

An expert that has over 10 points.

Mayor:

An expert whose answer got voted for 2 times.

Problem Solver:

An expert who has answered 5 questions.

Joined: Jun 19, 2009
Answers
16
Questions
0
Helped
6713
Points
27

A KM-450 MAB at 70 air and 50 water will produce approx. 460 lbs. cycle weight should be 10.4 lbs. per batch this is of course in perfect cond. time to make is 30 min. freeze and 4 min . Harvest. To give you the worst case scenario 100 air 90 water you drop to 340 lbs. cycle weight is the same but time to make is 32 min. 3.5 harvest. If you have more ?s I have included the link to the Manual for this unit.

http://www.hoshizakiamerica.com/techsupport/tech.asp?


Dennis Boxerman

Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

  • Hoshizaki Master 1,306 Answers
  • Posted on Jun 05, 2009
Dennis Boxerman
Hoshizaki Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Joined: Feb 07, 2009
Answers
1306
Questions
1
Helped
646830
Points
2787

The way I understand how Hoshizaki machines work, the model number is usually what the unit will produce, in pounds of ice. Their manual states: "Approximate production/ 24 hours @ 70 degrees air/ 50 degrees water (incoming)" So, yours should be producing 450 pounds a day, approimately. Since I can not pin point your exact model, I found one that is close. It states: "Ice Production per cycle: 6.6 pounds, 360 pcs." Again, it is not you exact machine. Their web site does not show this model either. So this is the best info I can get for you. Hope this helps.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

Why would a hoshikia 450 mab jump from freeze cycle to harvest cycle without giving iot enough time to makle aload. would it be the cube sizer adjustment or a bad borard?

clean and dry the sensor and restart the machine. Adjust the thickness until the cubes make a plate but break apart when they fall in the storage bin
0helpful
1answer

WHAT IS THE CAPACITY OF MODEL F-450BAE FLAKER

It is to produce 450 pounds of ice in 24 hours under ideal conditions. Manual says anywhere from 345 to 440 depending on factors of water temp., ambient temp., and system pressures.
Hope this is what you are looking for.
0helpful
1answer

I have a hoshizaki km-250bwf and it the comprsser

Check the control board for a "output" test switch.
If it is "ON",turn it off.
0helpful
1answer

Beeping 3 times every 3 seconds

The 3 beeps indicates that the unit was in the freeze cycle for 60 minutes. Causes: 1.) Water valve leaking, allowing water to continually enter the system. 2.) Float switch stuck, sending false signal to board. This indicates ice not being produced. 3,.) Low freon level causing long freeze cycle. 4.) Hot gas valve leaking thru causing warmer than normal evap plates=low production. 5.) Expansion Valve not feeding freon properly to evap plates.
Items 1 and 2 are the most common. Number 3 possible due to freon leak in the system. Number 4 and 5 are usually a very rare occurance.
Hope this helps ya.
0helpful
1answer

Not producing ice like it should

Just what does this mean? Does it seem to have a lower production? Let me know and I'll give you a hand in correcting.
2helpful
1answer

Hoshizaki ice machine with constant beeping every 2 seconds

turn it off and on and check the drain line and see if its draining water. some times the check valve needs taken apart and cleaned. the problems corespond to water related problems. usually because its taking too long to freeze. good luck
1helpful
1answer

KM 280MAH

Check the condenser if it is restricted in any way it will decrease ice production. Check for water overflow from the sump. Any more water than necessary entering the sump will also cause a decrease in ice production.
4helpful
2answers

Harvest cycle on ice machines

My ice machine Hoshizaki km-500 mah is cycling to fast. Causing poor production of ice it's real small and it doesn't produce enough ice aswell. Wha seems to be the problem.
1helpful
1answer

Hoshizaki KM-500MAH not making ice

Look at water solenoid valve when the unit is running in ice mode. Check to see if the water is shuting off completely. If the water valve does not close properly it will keep adding a little bit warm water to the ice a slow down the ice production.
Not finding what you are looking for?

369 views

Ask a Question

Usually answered in minutes!

Top Hoshizaki Freezers Experts

ADMIN Andrew
ADMIN Andrew

Level 3 Expert

66931 Answers

David Spradling
David Spradling

Level 3 Expert

13522 Answers

Steve Pack
Steve Pack

Level 3 Expert

7128 Answers

Are you a Hoshizaki Freezer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...