The outside cover (Bearing Housing (#4 in diagram) does not come out because it is partially blocked by the Slide Housing Cover (#52).
Would appreciate any suggestions.
If you remove the cover (#53)(4 bolts #104) then the the bearing end plate will come out,but the armature will also come out as the bearing is pressed onto the armature.If you want to get the two apart you will have to unthread the bearing cover(#6), then remove the nut below it(#9) then press the armature out of the bearing.
2,834 views
Usually answered in minutes!
thank you. Your #s are different from my diagram. I have the following two diagrams (for model 0611304034 and model 0611304139).
The nameplate on my hammer is missing, so I can not tell for sure what model I have.
Would you please post the link to the diagram you are using?
×