SOURCE: Asko W620 washing machine not spinning
Sounds like the motor brushes need to be cleaned or replaced. Take the back off the washer, remove the motor and gently scrape the excess carbon or debris off the brushes with a pocket knife. I did this and it ran well for about 50 loads before building back up. I am ordering new brushes now because when I checked the brushes last week they were obviously worn more than 4 weeks ago.
SOURCE: Asko Washer W6021 Problem
CHECK THE BRUSHES ON THE MOTOR, FOR BEING WORN DOWN!
REGARDS........TREVOR. FLEETWOOD UK.
SOURCE: asko 10625 will not spin
it is probably the belt, take off the back of the machine and look at the black rubber belt that spins the cleaning drum. The belts break after about 5 years, you can get a replacement belt at you local Asko dealer, I recall that is was pretty easy to change, like doing a bike chain, Talk to you Asko dealer about how to change it.
SOURCE: lg 801 3f washing machine. 15 seconds after selecting any cycle a
I had the same problem. Redistributing the clothes inside the machine seems to do the trick. Even though the clothes seemed evenly distributed and I had far less than maximum capacity in the machine- it seemed to think that something was out of sync- simply moving the clothes around did the trick!
SOURCE: I have an Admiral Capacity
This symptom characterizes a problem with the water level pressure switch which is not tripping from the empty to full position. Either the pressure switch contacts are stuck or has welded together or the pressure hose is detached or has air leaks preventing pressure build up to trigger the tripping of the pressure switch.The pressure switch is located behind the console and directly attached to the water level selection switch with a small clear hose connected to it.
Roll the console in the service position to access the pressure switch. Disconnect the pressure hose then blow air forcefully down through it to clear for possible clogs. Do the same with the pressure switch inlet to free any possible stuck or welded contacts. Replace the pressure switch, part number 21001882, if the problem persists.
793 views
Usually answered in minutes!
×