How to program a ezsdei474 remote to a viper 130xv

Dear Marta,

Here is a hands on to watch and program as you go. Follow to the link. How To program DEI Viper Python Avital Sidewinder Valet Hornet Alarm...


Here is another look. 1f Responder LE Remote Pairing



For your direct contact to Viper follow this link for any question. Viper Support



Fare. Well.

you're going to have to call the manufacturer to get those answers.

get in vehicle turn key on with new key fob in car, let run for 20 or so then turn off . hit the unlock button it should be programmed but not promising anything lol

SOUNDS LIKE YOU HAVE ALARM IN SILENT MODE

If you need further help, I’m available over the phone at https://www.6ya.com/expert/stephen_fa62cb6d50fe05e8

Viper or Python (RPN7701V/P/X) programming instructions: http://www.bluexray.com/viper7701/

To enter programming mode Press the Program button on the back of the remote or hold the four remote control buttons on the front of the remote simultaneously until one long beep is heard. Programming Mode has now been entered.
Beep/Vibrate Mode Within five seconds of entering Programming Mode, press Lock. The remote control will beep once for on, twice for off. The vibrate icon (13) will also turn on/off with each press.
Here's the owners manual for that system: http://www.directeddealers.com/manuals/og/viper/G5301V_05-06post.pdf
remote programming starts on page 15.

go to www.directed.com this is the manufacturer of the viper remote starters, there you should be able to download instructions.

Here is how you program the viper 5101 remote.

Programming the Viper Remote Starter 5101

Unlock the doors before starting

Push and hold f button for 8-10 seconds until amber light is on solid

Push Remote start button for about 4 seconds till amber light flashes 3 times

Put key in IGN to the on position but don

I can email it to you. My email address is [email protected]. Put Viper 130XV in the subject line

Try this first, unplug the 2-way antenna on your windshield. Let it sit for at least a few minutes. Try recoding the remotes after you replug the antenna back in. This is an issue i have seen on some of the Viper units. Usually they never have issues, but here and there they need reset.

The Viper alarms will accept (if I remember correctly), 4 codes at one time. That is, 4 individual remotes, or two remotes two times, or one remote 4 times. So, if you program your remote 4 times, it will essentially remove any previously programmed remotes. Another option, and you'll have to check with your dealer, but I think there is a way to delete ALL remotes, and then program your remaining remote one time, and again, all previously programmed remotes are now removed from memory. This was done by the manufacturer just for such events.