Belt is fine but drum not turning
SOURCE: WASHING MACHINE DRUM WILL NOT TURN
There is no adjustment provided for lining up the pulleys.
If it comes off then there are a couple of reasons that come to mind,the belt is too slack, the belt is worn,the drum is out of alignment with the motor pulley, caused by worn drum bearings, the motor is loose, a loose drum pulley, or you are not lining the belt up properly, overloading can also throw the belt off.
Hope this helps.
Plz leave feedback.
Ta.
SOURCE: drum not turning
If you are certain that the motor was turning, then the only things that come to mind are that:
Try running it on fast spin without the belt on , if it spins o/k, then that would indicate the motor is o/k.
Please leave a fixya rating for my solution.
Thanks.
SOURCE: hello i have a hotpoint wma40 the machine will go
Hi, i have a wma40s had it for 7 ears now same thing happended would start a cycle but then stop halfway through make the noise but the drum would not spin etc. i bought some carbon brushes of ebay for 7 quid and it works better than its worked in years bit nosiey for first few washes but after it settles it is as good as new.
SOURCE: My WF000 drum has stopped
The drum should spin freely with the belt off, there should be no resistance, if there is, then it could be main bearing problem, or somethig stuck between inner and outer drum.
SOURCE: My washing machine drum wont turn. The washing
hello. if it don't turn then it could be the brushes on the motor also check the interlock on the door. any spin problems could be the module control board get back to me if you still have problems
regards
shaun
Testimonial: "Many thanks for the advice regarding my washing machine. The brushes have now been replaced and the washing machine is once again working."
47 views
Usually answered in minutes!
×